Lines Matching full:default

65 not turned on by default in the U-Boot source tree. Firstly, you need turn it
245 default u-boot.rom image for this board is set to 2MB, it should be programmed  label
273 http://firmware.intel.com/sites/default/files/2014-WW42.4-MinnowBoardMax.73-64-bit.bin_Release.zip
321 the default value 0xfffc0000.
384 Note this default configuration will build a U-Boot for the QEMU x86 i440FX
390 	(qemu-x86_q35) Default Device Tree for DT control
396 binary, as well as other supported payloads. With the default configuration,
435 Note by default QEMU instantiated boards only have 128 MiB system memory. But
499 By default Intel Edison boards are shipped with preinstalled heavily
865 as in their default state. Then,
959 These are written to arch/x86/dts/microcode/ by default.
1006 chipset, the power-up default mapping is INTA/B/C/D maps to PIRQA/B/C/D. This
1008 registers so we can write down the PIRQ according to the default mapping rule.
1043 but by default they are held in reset after power on. In U-Boot, PCIe