Lines Matching full:ethernet

64 CONFIG_USB_HOST_ETHER	enables USB ethernet adapter support
70 If you have a supported USB Ethernet adapter you can use it in U-Boot
74 client. In that case your board is pretending to be an Ethernet adapter
79 Ethernet adapter to which it is directly connected and the connection to
80 the outside world is your adapter's Ethernet cable. Your board becomes an
125 To enable USB Host Ethernet in U-Boot, your platform must of course
130 CONFIG_USB_HOST_ETHER=y		/* Enable USB Ethernet adapters */
177        scanning bus for ethernet devices... 1 Ethernet Device(s) found
181 You can see that it found an ethernet device and we can print out the
188 Waiting for Ethernet connection... done.
212 Most Ethernet dongles have a built-in MAC address which is unique in the
217 Some boards have USB Ethernet chips on-board, and these sometimes do not
222 Built-in Ethernet adapters support setting the MAC address by means of
229 So if your USB Ethernet chip doesn't have a MAC address available then