Lines Matching +full:vsc9953 +full:- +full:switch
1 This file contains information for VSC9953, a Vitesse L2 Switch IP
6 VSC9953 is an 8-port Gigabit Ethernet switch supports the following features:
7 - 8192 MAC addresses
8 - Static Address provisioning
9 - Dynamic learning of MAC addresses and aging
10 - 4096 VLANs
11 - Independent and shared VLAN learning (IVL, SVL)
12 - Policing with storm control and MC/BC protection
13 - IPv4 and IPv6 multicast
14 - Jumbo frames (9.6 KB)
15 - Access Control List
16 - VLAN editing, translation and remarking
17 - RMON counters per port
19 Switch interfaces:
20 - 8 Gigabit switch ports (ports 0 to 7) are external and are connected to external PHYs
21 - 2 switch ports (ports 8 and 9) of 2.5 G are connected (fixed links)
27 - enable/disable a port or show its configuration (speed, duplexity, status, etc.)
28 - port statistics
29 - MAC learning
30 - add/remove FDB entries
31 - Port-based VLAN
32 - Private/Shared VLAN learning
33 - VLAN ingress filtering
34 - Port LAG
37 ethsw [port <port_no>] { enable | disable | show } - enable/disable a port; show a port's configura…
38 ethsw [port <port_no>] statistics { [help] | [clear] } - show an l2 switch port's statistics
39 ethsw [port <port_no>] learning { [help] | show | auto | disable } - enable/disable/show learning c…
40 ethsw [port <port_no>] [vlan <vid>] fdb { [help] | show | flush | { add | del } <mac> } - add/delet…
42 ethsw [port <port_no>] pvid { [help] | show | <pvid> } - set/show PVID (ingress and egress VLAN tag…
43 ethsw [port <port_no>] vlan { [help] | show | add <vid> | del <vid> } - add a VLAN to a port (VLAN …
44 ethsw [port <port_no>] untagged { [help] | show | all | none | pvid } - set egress tagging mode for…
45 ethsw [port <port_no>] egress tag { [help] | show | pvid | classified } - configure VID source for …
47 ethsw vlan fdb { [help] | show | shared | private } - make VLAN learning shared or private
48 ethsw [port <port_no>] ingress filtering { [help] | show | enable | disable } - enable/disable VLAN…
49 ethsw [port <port_no>] aggr { [help] | show | <lag_group_no> } - get/set LAG group for a port
57 4 disabled down - half
58 5 disabled down - half
59 6 disabled down - half
60 7 disabled down - half