Lines Matching +full:tpl +full:- +full:support

5 pre-mechanism is required to load the DDR with the bootloader binary.
6 - In case of SD and SPI boot this is done by BootROM code inside the chip
8 - In case of NAND boot FCM supports loading initial 4K code from NAND flash
18      - In very early stage of platform bringup where other boot options are not
20      - In case the support to program the flashes on the board is not available.
25       - While developing some new feature of u-boot, for example USB driver or
31      - Suppose a platform already has a propreitery bootloader which does not
32        support for example AMP boot. In this case also RAM boot loader can be
41 The main difference among all of them is the way the pre-environment is getting
43 - In case of SD card and SPI flash bootloader this is done by On Chip BootROM inside the Si itself.
44 - In case of NAND boot SPL/TPL code does it with some support from Si itself.
45 - In case of the pure RAM based bootloaders we have to do it by JTAG manually or already existing b…
52 	- setup DDR controller registers.
53 	- setup DDR LAWs
54 	- setup DDR TLB
62       => tftp 11000000 u-boot-ram.bin
76 In the 2nd case bootloader has already re-located CCSRBAR to 0xffe00000
78 1. File name-> boards.cfg