Lines Matching refs:board
43 - <board>_defconfig
49 - <board>_config
52 "make <board>_config" works the same as "make <board>_defconfig".
53 Prior to Kconfig, in U-Boot, "make <board>_config" was used for the
64 Prior to Kconfig, the C preprocessor based board configuration had been used
76 - include/configs/<board>.h (exists for all boards)
109 When adding a new board, the following steps are generally needed:
115 Define CONFIG_SYS_VENDOR="vendor" to compile board/<vendor>/common/*
116 and board/<vendor>/<board>/*
117 Define CONFIG_SYS_BOARD="board" to compile board/<board>/*
118 (or board/<vendor>/<board>/* if CONFIG_SYS_VENDOR is defined)
121 [3] Add a new entry to the board select menu in Kconfig.
122 The board select menu is located in arch/<arch>/Kconfig or
125 It is generally placed at board/<board>/MAINTAINERS or
126 board/<vendor>/<board>/MAINTAINERS
129 When removing an obsolete board, the following steps are generally needed:
133 [3] Remove board/<vendor>/<board>/* or board/<board>/* if it is not used
136 [5] Remove the unused entry from the board select menu in Kconfig
149 - In the pre-Kconfig, a single board had multiple entries in the boards.cfg
153 recommended to have only one defconfig per board and allow users to select