Lines Matching full:card

20 - Transfer to an uSD card (see "microSD card" below)
80 1) Reading 32KB from sector 16 (@8K) of the microSD card to SRAM A1. If the
82 code. If not (no SD card at all or invalid magic), it will:
108 microSD card
110 Transfer the SPL and the U-Boot FIT image directly to an uSD card:
114 (replace /dev/sdx with you SD card device file name, which could be
121 You can partition the microSD card, but leave the first MB unallocated (most
129 Create the SPL and FIT image like described above for the SD card.
133 Remove a microSD card from the slot and power on the board.
141 Now boot the board without an SD card inserted and you should see the
147 of SPL replacement to get U-Boot up and running from an microSD card.
157 SD card or an image file:
159 where /dev/sd<x> is the device name of the uSD card or the name of the image
164 The original boot0 code looks for U-Boot at a certain place on an uSD card
171 places on the uSD card and works around unused, but mandatory parts by using
177 Then write this image to a microSD card, replacing /dev/sdx with the right