Lines Matching +full:convert +full:- +full:rate
3 U-Boot for Wind River SBC834x Boards
8 design that uses the MPC8347E or MPC8349E processor. U-Boot support
9 for this board is heavily based on the existing U-Boot support for
33 Note that U-Boot versions up to and including 2009.06 had essentially
34 two copies of U-Boot in flash; one at the very beginning, which set
39 Use of the U-Boot command "fli" will indicate what parts are in use.
40 Details for storing U-Boot to flash using a Wind River ICE can be found
41 on page 19 of the board manual (request ERG-00328-001). The following
44 - Connect ICE and establish connection to it from WorkBench/OCD.
45 - Ensure you have background mode (BKM) in the OCD terminal window.
46 - Select the appropriate flash type (listed above)
47 - Prepare a U-Boot image by using the Wind River Convert utility;
48 by using "Convert and Add file" on the ELF file from your build.
49 Convert from FF80_0000 to FFFF_FFFF (or to FF83_FFFF if you are
51 - Set the start address of the erase/flash process to FF80_0000
52 - Set the target RAM required to 64kB.
53 - Select sectors for erasing (see note on environment below)
54 - Select Erase and Reprogram.
58 by U-Boot when this register file is played to the target. Using
60 will not play the register file, and allow U-Boot to use the TSEC
68 If you wish to preserve your prior U-Boot environment settings,
69 then convert (and erase to) 0xFF83FFFF instead of 0xFFFFFFFF.
71 as u-boot.bin.
74 Updating U-Boot with U-Boot:
77 This procedure is very similar to other boards that have U-Boot installed.
78 Assuming that the network has been configured, and that the new u-boot.bin
81 tftp 200000 u-boot.bin
101 a base clock of 66MHz. Note that you need both PCI enabled in U-Boot
106 The second enables PCI support and builds for a 33MHz clock rate. Note
111 then you should build a U-Boot with sbc8349_PCI_33_config and store this
116 default 66MHz. This has been tested with an intel PCI-X e1000 card.
119 possibly add a PCI-X card at a later date.
123 BusDevFun VendorId DeviceId Device Class Sub-Class