Kconfig - OpenGrok cross reference for /openbmc/u-boot/arch/arm/mach-sunxi/Kconfig

91 	SRAM to a different address.
96 # Note only one of these may be selected at a time! But hidden choices are
114 	Select this for sunxi SoCs which uses a DRAM controller like the
321 # The sun8i SoCs share a lot, this helps to avoid a lot of "if A23 || A33"
337 	Prepend a 1536 byte (empty) header to the U-Boot image file, to be
350 	The very first instruction acts as a switch, since it's carefully
351 	chosen to be a NOP in one mode and a branch in the other, so the
415 	must be a multiple of 24. For the sun9i (A80), the tested values
502 	uses a bit faster timings than DDR3-1333H).
574 	  Set the pin used to power the MAC. This takes a string in the format
583 	takes a string in the format understood by sunxi_name_to_gpio, e.g.
608 	Set the pins used for mmc1, when applicable. This takes a string in the
627 	sunxi builds always enable mmc0, some boards also have a second sdcard
637 	option to a non 0 value to add an extra delay before the first usb
644 	Set the Vbus enable pin for usb0 (otg). This takes a string in the
651 	Set the Vbus detect pin for usb0 (otg). This takes a string in the
658 	Set the ID detect pin for usb0 (otg). This takes a string in the
667 	a string in the format understood by sunxi_name_to_gpio, e.g.
755 	Say Y here to add support for using a cfb console on the HDMI, LCD
779 	LCD interface driving a VGA connector, such as found on the
787 	Say Y here if you've a board which uses opendrain drivers for the vga
789 	positive edges for a stable video output, so on boards with opendrain
797 	Set the enable pin for the external VGA DAC. This takes a string in the
829 	Set the power enable pin for the LCD panel. This takes a string in the
837 	Set the reset pin for the LCD panel. This takes a string in the format
845 	Set the backlight enable pin for the LCD panel. This takes a string in the
854 	Set the backlight pwm pin for the LCD panel. This takes a string in the
871 	will add a bitbang i2c controller using gpios to talk to the LCD.
878 	Set the SDA pin for the LCD i2c interface. This takes a string in the
886 	Set the SCL pin for the LCD i2c interface. This takes a string in the
890 # Note only one of these may be selected at a time! But hidden choices are
965 	  Set the pins used to power the SATA. This takes a string in the