Lines Matching +full:avdd +full:- +full:dsi +full:- +full:csi +full:- +full:supply
5 * This file is dual-licensed: you can use it either under the terms
44 /dts-v1/;
45 #include "sun8i-a83t.dtsi"
47 #include <dt-bindings/gpio/gpio.h>
48 #include <dt-bindings/pwm/pwm.h>
52 compatible = "tbs-biometrics,a711", "allwinner,sun8i-a83t";
60 stdout-path = "serial0:115200n8";
64 compatible = "pwm-backlight";
66 enable-gpios = <&pio 3 29 GPIO_ACTIVE_HIGH>;
68 brightness-levels = <0 1 2 4 8 16 32 64 128 255>;
69 default-brightness-level = <9>;
73 compatible = "tbs,a711-panel", "panel-lvds";
75 power-supply = <®_sw>;
77 width-mm = <153>;
78 height-mm = <90>;
79 data-mapping = "vesa-24";
81 panel-timing {
83 clock-frequency = <52000000>;
86 hsync-len = <20>;
87 hfront-porch = <180>;
88 hback-porch = <160>;
89 vfront-porch = <12>;
90 vback-porch = <23>;
91 vsync-len = <5>;
96 remote-endpoint = <&tcon0_out_lcd>;
101 reg_vbat: reg-vbat {
102 compatible = "regulator-fixed";
103 regulator-name = "vbat";
104 regulator-min-microvolt = <3700000>;
105 regulator-max-microvolt = <3700000>;
108 reg_vmain: reg-vmain {
109 compatible = "regulator-fixed";
110 regulator-name = "vmain";
111 regulator-min-microvolt = <5000000>;
112 regulator-max-microvolt = <5000000>;
114 enable-active-high;
115 vin-supply = <®_vbat>;
119 compatible = "mmc-pwrseq-simple";
120 reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* PL2 WL-PMU-EN */
127 clock-names = "ext_clock";
132 cpu-supply = <®_dcdc2>;
136 cpu-supply = <®_dcdc3>;
144 * An USB-2 hub is connected here, which also means we don't need to
160 vmmc-supply = <®_dcdc1>;
161 pinctrl-names = "default";
162 pinctrl-0 = <&mmc0_pins>;
163 cd-gpios = <&pio 5 6 GPIO_ACTIVE_LOW>;
168 mmc-pwrseq = <&wifi_pwrseq>;
169 bus-width = <4>;
170 vmmc-supply = <®_dldo1>;
171 vqmmc-supply = <®_dldo1>;
172 non-removable;
173 wakeup-source;
178 compatible = "brcm,bcm4329-fmac";
179 interrupt-parent = <&r_pio>;
181 interrupt-names = "host-wake";
186 pinctrl-0 = <&mmc2_8bit_emmc_pins>;
187 pinctrl-names = "default";
188 vmmc-supply = <®_dcdc1>;
189 vqmmc-supply = <®_dcdc1>;
190 bus-width = <8>;
191 non-removable;
192 cap-mmc-hw-reset;
197 pinctrl-names = "default";
198 pinctrl-0 = <&pwm_pin>;
206 compatible = "x-powers,axp813";
208 interrupt-parent = <&r_intc>;
210 swin-supply = <®_dcdc1>;
211 x-powers,drive-vbus-en;
215 compatible = "x-powers,ac100";
219 compatible = "x-powers,ac100-codec";
220 interrupt-parent = <&r_pio>;
222 #clock-cells = <0>;
223 clock-output-names = "4M_adda";
227 compatible = "x-powers,ac100-rtc";
228 interrupt-parent = <&r_intc>;
231 #clock-cells = <1>;
232 clock-output-names = "cko1_rtc",
247 regulator-min-microvolt = <1800000>;
248 regulator-max-microvolt = <1800000>;
249 regulator-name = "vcc-1.8";
253 regulator-min-microvolt = <1800000>;
254 regulator-max-microvolt = <1800000>;
255 regulator-always-on;
256 regulator-name = "vdd-drampll";
260 regulator-min-microvolt = <3000000>;
261 regulator-max-microvolt = <3000000>;
262 regulator-always-on;
263 regulator-name = "avcc";
267 regulator-min-microvolt = <3100000>;
268 regulator-max-microvolt = <3100000>;
269 regulator-always-on;
270 regulator-name = "vcc-io";
274 regulator-min-microvolt = <700000>;
275 regulator-max-microvolt = <1100000>;
276 regulator-always-on;
277 regulator-name = "vdd-cpu-A";
281 regulator-min-microvolt = <700000>;
282 regulator-max-microvolt = <1100000>;
283 regulator-always-on;
284 regulator-name = "vdd-cpu-B";
288 regulator-min-microvolt = <700000>;
289 regulator-max-microvolt = <1100000>;
290 regulator-name = "vdd-gpu";
294 regulator-min-microvolt = <1200000>;
295 regulator-max-microvolt = <1500000>;
296 regulator-always-on;
297 regulator-name = "vcc-dram";
301 regulator-min-microvolt = <900000>;
302 regulator-max-microvolt = <900000>;
303 regulator-always-on;
304 regulator-name = "vdd-sys";
308 regulator-min-microvolt = <3100000>;
309 regulator-max-microvolt = <3100000>;
310 regulator-name = "vcc-wifi-io";
314 regulator-min-microvolt = <2800000>;
315 regulator-max-microvolt = <4200000>;
316 regulator-name = "vcc-mipi";
320 regulator-min-microvolt = <2800000>;
321 regulator-max-microvolt = <2800000>;
322 regulator-name = "vdd-csi";
326 regulator-min-microvolt = <2800000>;
327 regulator-max-microvolt = <2800000>;
328 regulator-name = "avdd-csi";
332 regulator-name = "usb0-vbus";
337 regulator-min-microvolt = <1200000>;
338 regulator-max-microvolt = <1800000>;
339 regulator-name = "dvdd-csi-r";
343 regulator-min-microvolt = <1800000>;
344 regulator-max-microvolt = <1800000>;
345 regulator-name = "vcc-dsi";
349 regulator-min-microvolt = <1200000>;
350 regulator-max-microvolt = <1800000>;
351 regulator-name = "dvdd-csi-f";
355 regulator-min-microvolt = <1200000>;
356 regulator-max-microvolt = <1200000>;
357 regulator-name = "vcc-hsic";
361 regulator-min-microvolt = <700000>;
362 regulator-max-microvolt = <1100000>;
363 regulator-always-on;
364 regulator-name = "vdd-cpus";
368 regulator-min-microvolt = <3100000>;
369 regulator-max-microvolt = <3100000>;
370 regulator-name = "vcc-ctp";
375 regulator-min-microvolt = <3100000>;
376 regulator-max-microvolt = <3100000>;
377 regulator-name = "vcc-vb";
382 regulator-min-microvolt = <3100000>;
383 regulator-max-microvolt = <3100000>;
384 regulator-name = "vcc-lcd";
388 pinctrl-names = "default";
389 pinctrl-0 = <&lcd_lvds_pins>;
395 remote-endpoint = <&panel_input>;
400 pinctrl-names = "default";
401 pinctrl-0 = <&uart0_pb_pins>;
407 pinctrl-names = "default";
408 pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
418 usb0_id_det-gpios = <&pio 7 11 GPIO_ACTIVE_HIGH>; /* PH11 */
419 usb0_vbus-supply = <®_drivevbus>;