Lines Matching +full:button +full:- +full:392
4 * Maxime Ripard <maxime.ripard@free-electrons.com>
6 * This file is dual-licensed: you can use it either under the terms
45 /dts-v1/;
46 #include "sun5i-a13.dtsi"
47 #include "sunxi-common-regulators.dtsi"
49 #include <dt-bindings/gpio/gpio.h>
50 #include <dt-bindings/input/input.h>
53 model = "Olimex A13-Olinuxino";
54 compatible = "olimex,a13-olinuxino", "allwinner,sun5i-a13";
61 stdout-path = "serial0:115200n8";
65 compatible = "gpio-leds";
66 pinctrl-names = "default";
67 pinctrl-0 = <&led_pins_olinuxino>;
71 default-state = "on";
76 compatible = "dumb-vga-dac";
77 #address-cells = <1>;
78 #size-cells = <0>;
81 #address-cells = <1>;
82 #size-cells = <0>;
88 remote-endpoint = <&tcon0_out_vga>;
96 remote-endpoint = <&vga_con_in>;
103 compatible = "vga-connector";
107 remote-endpoint = <&vga_bridge_out>;
126 pinctrl-names = "default";
127 pinctrl-0 = <&i2c0_pins_a>;
131 compatible = "x-powers,axp209";
135 interrupt-controller;
136 #interrupt-cells = <1>;
141 pinctrl-names = "default";
142 pinctrl-0 = <&i2c1_pins_a>;
147 pinctrl-names = "default";
148 pinctrl-0 = <&i2c2_pins_a>;
153 vref-supply = <®_vcc3v0>;
156 button@191 {
163 button@392 {
170 button@601 {
177 button@795 {
184 button@987 {
193 pinctrl-names = "default";
194 pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_olinuxino>;
195 vmmc-supply = <®_vcc3v3>;
196 bus-width = <4>;
197 cd-gpios = <&pio 6 0 GPIO_ACTIVE_LOW>; /* PG0 */
213 bias-pull-up;
219 drive-strength = <20>;
225 bias-pull-up;
231 bias-pull-down;
246 pinctrl-0 = <&usb1_vbus_pin_olinuxino>;
252 pinctrl-names = "default";
253 pinctrl-0 = <&lcd_rgb666_pins>;
260 remote-endpoint = <&vga_bridge_in>;
265 pinctrl-names = "default";
266 pinctrl-0 = <&uart1_pins_b>;
276 pinctrl-names = "default";
277 pinctrl-0 = <&usb0_id_detect_pin>, <&usb0_vbus_detect_pin>;
278 usb0_id_det-gpio = <&pio 6 2 GPIO_ACTIVE_HIGH>; /* PG2 */
279 usb0_vbus_det-gpio = <&pio 6 1 GPIO_ACTIVE_HIGH>; /* PG1 */
280 usb0_vbus-supply = <®_usb0_vbus>;
281 usb1_vbus-supply = <®_usb1_vbus>;