arm/dts/sun4i-a10-olinuxino-lime.dts

2  * Copyright 2014 - Hans de Goede <hdegoede@redhat.com>
4  * This file is dual-licensed: you can use it either under the terms
43 /dts-v1/;
44 #include "sun4i-a10.dtsi"
45 #include "sunxi-common-regulators.dtsi"
47 #include <dt-bindings/gpio/gpio.h>
50 	model = "Olimex A10-OLinuXino-LIME";
51 	compatible = "olimex,a10-olinuxino-lime", "allwinner,sun4i-a10";
58 		stdout-path = "serial0:115200n8";
61 	hdmi-connector {
62 		compatible = "hdmi-connector";
67 				remote-endpoint = <&hdmi_out_con>;
73 		compatible = "gpio-leds";
74 		pinctrl-names = "default";
75 		pinctrl-0 = <&led_pins_olinuxinolime>;
78 			label = "a10-olinuxino-lime:green:usr";
80 			default-state = "on";
85 &ahci {
86 	target-supply = <&reg_ahci_5v>;
92 	 * The A10-Lime is known to be unstable when running at 1008 MHz
94 	operating-points = <
129 		remote-endpoint = <&hdmi_con_in>;
137 		compatible = "x-powers,axp209";
141 		interrupt-controller;
142 		#interrupt-cells = <1>;
159 	phy1: ethernet-phy@1 {
165 	vmmc-supply = <&reg_vcc3v3>;
166 	bus-width = <4>;
167 	cd-gpios = <&pio 7 1 GPIO_ACTIVE_LOW>; /* PH1 */
184 	led_pins_olinuxinolime: led-pin {
187 		drive-strength = <20>;
190 	usb0_id_detect_pin: usb0-id-detect-pin {
193 		bias-pull-up;
196 	usb0_vbus_detect_pin: usb0-vbus-detect-pin {
199 		bias-pull-down;
221 	pinctrl-names = "default";
222 	pinctrl-0 = <&uart0_pb_pins>;
232 	pinctrl-names = "default";
233 	pinctrl-0 = <&usb0_id_detect_pin>, <&usb0_vbus_detect_pin>;
234 	usb0_id_det-gpio   = <&pio 7 4 GPIO_ACTIVE_HIGH>; /* PH4 */
235 	usb0_vbus_det-gpio = <&pio 7 5 GPIO_ACTIVE_HIGH>; /* PH5 */
236 	usb0_vbus-supply   = <&reg_usb0_vbus>;
237 	usb1_vbus-supply = <&reg_usb1_vbus>;
238 	usb2_vbus-supply = <&reg_usb2_vbus>;