arm/dts/sun4i-a10-a1000.dts

6  * This file is dual-licensed: you can use it either under the terms
45 /dts-v1/;
46 #include "sun4i-a10.dtsi"
47 #include "sunxi-common-regulators.dtsi"
49 #include <dt-bindings/gpio/gpio.h>
53 	compatible = "mele,a1000", "allwinner,sun4i-a10";
60 		stdout-path = "serial0:115200n8";
64 		compatible = "gpio-leds";
74 			default-state = "on";
78 	reg_emac_3v3: emac-3v3 {
79 		compatible = "regulator-fixed";
80 		regulator-name = "emac-3v3";
81 		regulator-min-microvolt = <3300000>;
82 		regulator-max-microvolt = <3300000>;
83 		startup-delay-us = <20000>;
84 		enable-active-high;
89 		compatible = "simple-audio-card";
90 		simple-audio-card,name = "On-board SPDIF";
92 		simple-audio-card,cpu {
93 			sound-dai = <&spdif>;
96 		simple-audio-card,codec {
97 			sound-dai = <&spdif_out>;
101 	spdif_out: spdif-out {
102 		#sound-dai-cells = <0>;
103 		compatible = "linux,spdif-dit";
107 &ahci {
116 	cpu-supply = <&reg_dcdc2>;
140 		compatible = "x-powers,axp209";
144 		interrupt-controller;
145 		#interrupt-cells = <1>;
150 	pinctrl-names = "default";
151 	pinctrl-0 = <&ir0_rx_pins>;
156 	phy-supply = <&reg_emac_3v3>;
159 	phy1: ethernet-phy@1 {
165 	vmmc-supply = <&reg_vcc3v3>;
166 	bus-width = <4>;
167 	cd-gpios = <&pio 7 1 GPIO_ACTIVE_LOW>; /* PH1 */
182 	regulator-always-on;
183 	regulator-min-microvolt = <1000000>;
184 	regulator-max-microvolt = <1400000>;
185 	regulator-name = "vdd-cpu";
189 	regulator-always-on;
190 	regulator-min-microvolt = <1000000>;
191 	regulator-max-microvolt = <1250000>;
192 	regulator-name = "vdd-int-dll";
196 	regulator-name = "vdd-rtc";
200 	regulator-always-on;
201 	regulator-min-microvolt = <3000000>;
202 	regulator-max-microvolt = <3000000>;
203 	regulator-name = "avcc";
215 	pinctrl-names = "default";
216 	pinctrl-0 = <&spdif_tx_pin>;
221 	pinctrl-names = "default";
222 	pinctrl-0 = <&uart0_pb_pins>;
227 	usb1_vbus-supply = <&reg_usb1_vbus>;
228 	usb2_vbus-supply = <&reg_usb2_vbus>;