Lines Matching +full:wp +full:- +full:inverted
1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 /dts-v1/;
8 #include "meson-gxbb.dtsi"
9 #include <dt-bindings/gpio/gpio.h>
12 compatible = "friendlyarm,nanopi-k2", "amlogic,meson-gxbb";
20 stdout-path = "serial0:115200n8";
29 compatible = "gpio-leds";
32 label = "nanopi-k2:blue:stat";
34 default-state = "on";
35 panic-indicator;
39 vdd_5v: regulator-vdd-5v {
40 compatible = "regulator-fixed";
41 regulator-name = "VDD_5V";
42 regulator-min-microvolt = <5000000>;
43 regulator-max-microvolt = <5000000>;
46 vddio_ao18: regulator-vddio-ao18 {
47 compatible = "regulator-fixed";
48 regulator-name = "VDDIO_AO18";
49 regulator-min-microvolt = <1800000>;
50 regulator-max-microvolt = <1800000>;
53 vddio_ao3v3: regulator-vddio-ao3v3 {
54 compatible = "regulator-fixed";
55 regulator-name = "VDDIO_AO3.3V";
56 regulator-min-microvolt = <3300000>;
57 regulator-max-microvolt = <3300000>;
60 vddio_tf: regulator-vddio-tf {
61 compatible = "regulator-gpio";
63 regulator-name = "VDDIO_TF";
64 regulator-min-microvolt = <1800000>;
65 regulator-max-microvolt = <3300000>;
68 gpios-states = <0>;
73 regulator-settling-time-up-us = <100>;
74 regulator-settling-time-down-us = <5000>;
77 wifi_32k: wifi-32k {
78 compatible = "pwm-clock";
79 #clock-cells = <0>;
80 clock-frequency = <32768>;
84 sdio_pwrseq: sdio-pwrseq {
85 compatible = "mmc-pwrseq-simple";
86 reset-gpios = <&gpio GPIOX_6 GPIO_ACTIVE_LOW>;
88 clock-names = "ext_clock";
91 vcc1v8: regulator-vcc1v8 {
92 compatible = "regulator-fixed";
93 regulator-name = "VCC1.8V";
94 regulator-min-microvolt = <1800000>;
95 regulator-max-microvolt = <1800000>;
98 vcc3v3: regulator-vcc3v3 {
99 compatible = "regulator-fixed";
100 regulator-name = "VCC3.3V";
101 regulator-min-microvolt = <3300000>;
102 regulator-max-microvolt = <3300000>;
105 emmc_pwrseq: emmc-pwrseq {
106 compatible = "mmc-pwrseq-emmc";
107 reset-gpios = <&gpio BOOT_9 GPIO_ACTIVE_LOW>;
111 cvbs-connector {
112 compatible = "composite-video-connector";
117 remote-endpoint = <&cvbs_vdac_out>;
122 hdmi-connector {
123 compatible = "hdmi-connector";
128 remote-endpoint = <&hdmi_tx_tmds_out>;
136 pinctrl-0 = <&ao_cec_pins>;
137 pinctrl-names = "default";
138 hdmi-phandle = <&hdmi_tx>;
143 remote-endpoint = <&cvbs_connector_in>;
149 pinctrl-0 = <ð_rgmii_pins>;
150 pinctrl-names = "default";
152 phy-handle = <ð_phy0>;
153 phy-mode = "rgmii";
155 amlogic,tx-delay-ns = <2>;
157 snps,reset-gpio = <&gpio GPIOZ_14 0>;
158 snps,reset-delays-us = <0 10000 1000000>;
159 snps,reset-active-low;
162 compatible = "snps,dwmac-mdio";
163 #address-cells = <1>;
164 #size-cells = <0>;
166 eth_phy0: ethernet-phy@0 {
169 interrupt-parent = <&gpio_intc>;
178 pinctrl-0 = <&hdmi_hpd_pins>, <&hdmi_i2c_pins>;
179 pinctrl-names = "default";
184 remote-endpoint = <&hdmi_connector_in>;
190 pinctrl-0 = <&remote_input_ao_pins>;
191 pinctrl-names = "default";
195 gpio-line-names = "UART TX", "UART RX", "Power Control", "Power Key In",
205 gpio-line-names = /* Bank GPIOZ */
254 pinctrl-0 = <&pwm_e_pins>;
255 pinctrl-names = "default";
257 clock-names = "clkin0";
262 vref-supply = <&vddio_ao18>;
268 pinctrl-0 = <&sdio_pins>, <&sdio_irq_pins>;
269 pinctrl-1 = <&sdio_clk_gate_pins>;
270 pinctrl-names = "default", "clk-gate";
271 #address-cells = <1>;
272 #size-cells = <0>;
274 bus-width = <4>;
275 cap-sd-highspeed;
276 max-frequency = <200000000>;
278 non-removable;
279 disable-wp;
281 mmc-pwrseq = <&sdio_pwrseq>;
283 vmmc-supply = <&vddio_ao3v3>;
284 vqmmc-supply = <&vddio_ao18>;
287 compatible = "brcm,bcm4329-fmac";
295 pinctrl-0 = <&sdcard_pins>;
296 pinctrl-1 = <&sdcard_clk_gate_pins>;
297 pinctrl-names = "default", "clk-gate";
299 bus-width = <4>;
300 cap-sd-highspeed;
301 sd-uhs-sdr12;
302 sd-uhs-sdr25;
303 sd-uhs-sdr50;
304 sd-uhs-sdr104;
305 max-frequency = <200000000>;
306 disable-wp;
308 cd-gpios = <&gpio CARD_6 GPIO_ACTIVE_HIGH>;
309 cd-inverted;
311 vmmc-supply = <&vddio_ao3v3>;
312 vqmmc-supply = <&vddio_tf>;
318 pinctrl-0 = <&emmc_pins>, <&emmc_ds_pins>;
319 pinctrl-1 = <&emmc_clk_gate_pins>;
320 pinctrl-names = "default", "clk-gate";
322 bus-width = <8>;
323 max-frequency = <200000000>;
324 non-removable;
325 disable-wp;
326 cap-mmc-highspeed;
327 mmc-ddr-1_8v;
328 mmc-hs200-1_8v;
330 mmc-pwrseq = <&emmc_pwrseq>;
331 vmmc-supply = <&vcc3v3>;
332 vqmmc-supply = <&vcc1v8>;
338 pinctrl-0 = <&uart_ao_a_pins>;
339 pinctrl-names = "default";
345 pinctrl-0 = <&uart_a_pins>, <&uart_a_cts_rts_pins>;
346 pinctrl-names = "default";
349 /* 40-pin CON1 */
352 pinctrl-0 = <&uart_c_pins>;
353 pinctrl-names = "default";
358 phy-supply = <&vdd_5v>;