arm/dts/logicpd-som-lv.dtsi

7 #include <dt-bindings/input/input.h>
12 			cpu0-supply = <&vcc>;
22 		compatible = "regulator-fixed";
23 		regulator-name = "vwl1271";
24 		regulator-min-microvolt = <1800000>;
25 		regulator-max-microvolt = <1800000>;
27 		startup-delay-us = <70000>;
28 		enable-active-high;
29 		vin-supply = <&vaux3>;
34 		compatible = "usb-nop-xceiv";
35 		reset-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>; /* gpio_4 */
36 		#phy-cells = <0>;
41 		#clock-cells = <0>;
42 		compatible = "fixed-clock";
43 		clock-frequency = <26000000>;
51 		compatible = "ti,omap2-nand";
53 		interrupt-parent = <&gpmc>;
56 		linux,mtd-name = "micron,mt29f4g16abbda3w";
57 		nand-bus-width = <16>;
58 		ti,nand-ecc-opt = "bch8";
59 		rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 */
60 		gpmc,sync-clk-ps = <0>;
61 		gpmc,cs-on-ns = <0>;
62 		gpmc,cs-rd-off-ns = <44>;
63 		gpmc,cs-wr-off-ns = <44>;
64 		gpmc,adv-on-ns = <6>;
65 		gpmc,adv-rd-off-ns = <34>;
66 		gpmc,adv-wr-off-ns = <44>;
67 		gpmc,we-off-ns = <40>;
68 		gpmc,oe-off-ns = <54>;
69 		gpmc,access-ns = <64>;
70 		gpmc,rd-cycle-ns = <82>;
71 		gpmc,wr-cycle-ns = <82>;
72 		gpmc,wr-access-ns = <40>;
73 		gpmc,wr-data-mux-bus-ns = <0>;
74 		gpmc,device-width = <2>;
75 		#address-cells = <1>;
76 		#size-cells = <1>;
81 	pinctrl-names = "default";
82 	pinctrl-0 = <&i2c1_pins>;
83 	clock-frequency = <2600000>;
88 		interrupt-parent = <&intc>;
90 		clock-names = "fck";
92 			compatible = "ti,twl4030-audio";
101 	pinctrl-names = "default";
102 	pinctrl-0 = <&i2c2_pins>;
103 	clock-frequency = <400000>;
107 	pinctrl-names = "default";
108 	pinctrl-0 = <&i2c3_pins>;
109 	clock-frequency = <400000>;
111 	touchscreen: tsc2004@48 {  label
114 		vio-supply = <&vaux1>;
115 		pinctrl-names = "default";
116 		pinctrl-0 = <&tsc2004_pins>;
117 		interrupts-extended = <&gpio5 25 IRQ_TYPE_EDGE_RISING>; /* gpio 153 */
119 		touchscreen-fuzz-x = <4>;
120 		touchscreen-fuzz-y = <7>;
121 		touchscreen-fuzz-pressure = <2>;
122 		touchscreen-size-x = <4096>;
123 		touchscreen-size-y = <4096>;
124 		touchscreen-max-pressure = <2048>;
126 		ti,x-plate-ohms = <280>;
127 		ti,esd-recovery-timeout-ms = <8000>;
132 	interrupts-extended = <&intc 94 &omap3_pmx_core 0x136>;
133 	pinctrl-0 = <&mmc3_pins &wl127x_gpio>;
134 	pinctrl-names = "default";
135 	vmmc-supply = <&wl12xx_vmmc>;
136 	non-removable;
137 	bus-width = <4>;
138 	cap-power-off-card;
139 	#address-cells = <1>;
140 	#size-cells = <0>;
144 		interrupt-parent = <&gpio1>;
146 		ref-clock-frequency = <26000000>;
151 	port2-mode = "ehci-phy";
160 	pinctrl-names = "default";
161 	pinctrl-0 = <&hsusb2_pins>;
164 		pinctrl-single,pins = <
174 		pinctrl-single,pins = <
182 		pinctrl-single,pins = <
191 		pinctrl-single,pins = <
200 		pinctrl-single,pins = <
211 		pinctrl-single,pins = <
228 		pinctrl-single,pins = <
236 		pinctrl-single,pins = <
243 	pinctrl-names = "default";
244 	pinctrl-0 = <&hsusb2_reset_pin>;
246 		pinctrl-single,pins = <
251 		pinctrl-single,pins = <
257 		pinctrl-single,pins = <
263 		pinctrl-single,pins = <
271 	pinctrl-names = "default";
272 	pinctrl-0 = <&hsusb2_2_pins>;
274 		pinctrl-single,pins = <
286 	interrupts-extended = <&intc 73 &omap3_pmx_core OMAP3_UART2_RX>;
287 	pinctrl-names = "default";
288 	pinctrl-0 = <&uart2_pins>;
292 	pinctrl-names = "default";
293 	pinctrl-0 = <&mcspi1_pins>;
300 	regulator-min-microvolt = <2800000>;
301 	regulator-max-microvolt = <2800000>;
306 		compatible = "ti,twl4030-power-idle-osc-off", "ti,twl4030-power-idle";
312 	ti,use-leds;