Lines Matching +full:pllvdd +full:- +full:supply
1 // SPDX-License-Identifier: GPL-2.0+
6 #include <dt-bindings/clock/imx6qdl-clock.h>
7 #include <dt-bindings/gpio/gpio.h>
8 #include <dt-bindings/input/input.h>
16 stdout-path = &uart1;
24 compatible = "simple-bus";
25 #address-cells = <1>;
26 #size-cells = <0>;
29 compatible = "regulator-fixed";
31 regulator-name = "usb_otg_vbus";
32 regulator-min-microvolt = <5000000>;
33 regulator-max-microvolt = <5000000>;
35 enable-active-high;
36 vin-supply = <&swbst_reg>;
40 compatible = "regulator-fixed";
42 regulator-name = "usb_h1_vbus";
43 regulator-min-microvolt = <5000000>;
44 regulator-max-microvolt = <5000000>;
46 enable-active-high;
47 vin-supply = <&swbst_reg>;
51 compatible = "regulator-fixed";
53 regulator-name = "wm8962-supply";
55 enable-active-high;
59 compatible = "regulator-fixed";
61 pinctrl-names = "default";
62 pinctrl-0 = <&pinctrl_pcie_reg>;
63 regulator-name = "MPCIE_3V3";
64 regulator-min-microvolt = <3300000>;
65 regulator-max-microvolt = <3300000>;
67 enable-active-high;
71 gpio-keys {
72 compatible = "gpio-keys";
73 pinctrl-names = "default";
74 pinctrl-0 = <&pinctrl_gpio_keys>;
79 wakeup-source;
83 volume-up {
86 wakeup-source;
90 volume-down {
93 wakeup-source;
99 compatible = "fsl,imx6q-sabresd-wm8962",
100 "fsl,imx-audio-wm8962";
101 model = "wm8962-audio";
102 ssi-controller = <&ssi2>;
103 audio-codec = <&codec>;
104 audio-routing =
111 mux-int-port = <2>;
112 mux-ext-port = <3>;
115 backlight_lvds: backlight-lvds {
116 compatible = "pwm-backlight";
118 brightness-levels = <0 4 8 16 32 64 128 255>;
119 default-brightness-level = <7>;
124 compatible = "gpio-leds";
125 pinctrl-names = "default";
126 pinctrl-0 = <&pinctrl_gpio_leds>;
130 default-state = "on";
140 remote-endpoint = <&lvds0_out>;
147 bus-width = <8>;
148 data-shift = <12>; /* Lines 19:12 used */
149 hsync-active = <1>;
150 vsync-active = <1>;
154 remote-endpoint = <&ov5642_to_ipu1_csi0_mux>;
158 pinctrl-names = "default";
159 pinctrl-0 = <&pinctrl_ipu1_csi0>;
169 remote-endpoint = <&ov5640_to_mipi_csi2>;
170 clock-lanes = <0>;
171 data-lanes = <1 2>;
177 pinctrl-names = "default";
178 pinctrl-0 = <&pinctrl_audmux>;
183 assigned-clocks = <&clks IMX6QDL_CLK_LDB_DI0_SEL>,
185 assigned-clock-parents = <&clks IMX6QDL_CLK_PLL3_USB_OTG>,
190 cs-gpios = <&gpio4 9 0>;
191 pinctrl-names = "default";
192 pinctrl-0 = <&pinctrl_ecspi1>;
196 #address-cells = <1>;
197 #size-cells = <1>;
198 compatible = "st,m25p32", "jedec,spi-nor";
199 spi-max-frequency = <20000000>;
205 pinctrl-names = "default";
206 pinctrl-0 = <&pinctrl_enet>;
207 phy-mode = "rgmii";
208 phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
213 pinctrl-names = "default";
214 pinctrl-0 = <&pinctrl_hdmi_cec>;
215 ddc-i2c-bus = <&i2c2>;
220 clock-frequency = <100000>;
221 pinctrl-names = "default";
222 pinctrl-0 = <&pinctrl_i2c1>;
229 DCVDD-supply = <®_audio>;
230 DBVDD-supply = <®_audio>;
231 AVDD-supply = <®_audio>;
232 CPVDD-supply = <®_audio>;
233 MICVDD-supply = <®_audio>;
234 PLLVDD-supply = <®_audio>;
235 SPKVDD1-supply = <®_audio>;
236 SPKVDD2-supply = <®_audio>;
237 gpio-cfg = <
249 pinctrl-names = "default";
250 pinctrl-0 = <&pinctrl_ov5642>;
252 clock-names = "xclk";
254 DOVDD-supply = <&vgen4_reg>; /* 1.8v */
255 AVDD-supply = <&vgen3_reg>; /* 2.8v, rev C board is VGEN3
257 DVDD-supply = <&vgen2_reg>; /* 1.5v*/
258 powerdown-gpios = <&gpio1 16 GPIO_ACTIVE_HIGH>;
259 reset-gpios = <&gpio1 17 GPIO_ACTIVE_LOW>;
264 remote-endpoint = <&ipu1_csi0_mux_from_parallel_sensor>;
265 bus-width = <8>;
266 hsync-active = <1>;
267 vsync-active = <1>;
274 clock-frequency = <100000>;
275 pinctrl-names = "default";
276 pinctrl-0 = <&pinctrl_i2c2>;
281 pinctrl-names = "default";
282 pinctrl-0 = <&pinctrl_ov5640>;
285 clock-names = "xclk";
286 DOVDD-supply = <&vgen4_reg>; /* 1.8v */
287 AVDD-supply = <&vgen3_reg>; /* 2.8v, rev C board is VGEN3
289 DVDD-supply = <&vgen2_reg>; /* 1.5v*/
290 powerdown-gpios = <&gpio1 19 GPIO_ACTIVE_HIGH>;
291 reset-gpios = <&gpio1 20 GPIO_ACTIVE_LOW>;
295 remote-endpoint = <&mipi_csi2_in>;
296 clock-lanes = <0>;
297 data-lanes = <1 2>;
308 regulator-min-microvolt = <300000>;
309 regulator-max-microvolt = <1875000>;
310 regulator-boot-on;
311 regulator-always-on;
312 regulator-ramp-delay = <6250>;
316 regulator-min-microvolt = <300000>;
317 regulator-max-microvolt = <1875000>;
318 regulator-boot-on;
319 regulator-always-on;
320 regulator-ramp-delay = <6250>;
324 regulator-min-microvolt = <800000>;
325 regulator-max-microvolt = <3300000>;
326 regulator-boot-on;
327 regulator-always-on;
328 regulator-ramp-delay = <6250>;
332 regulator-min-microvolt = <400000>;
333 regulator-max-microvolt = <1975000>;
334 regulator-boot-on;
335 regulator-always-on;
339 regulator-min-microvolt = <400000>;
340 regulator-max-microvolt = <1975000>;
341 regulator-boot-on;
342 regulator-always-on;
346 regulator-min-microvolt = <800000>;
347 regulator-max-microvolt = <3300000>;
348 regulator-always-on;
352 regulator-min-microvolt = <5000000>;
353 regulator-max-microvolt = <5150000>;
357 regulator-min-microvolt = <1000000>;
358 regulator-max-microvolt = <3000000>;
359 regulator-boot-on;
360 regulator-always-on;
364 regulator-boot-on;
365 regulator-always-on;
369 regulator-min-microvolt = <800000>;
370 regulator-max-microvolt = <1550000>;
374 regulator-min-microvolt = <800000>;
375 regulator-max-microvolt = <1550000>;
379 regulator-min-microvolt = <1800000>;
380 regulator-max-microvolt = <3300000>;
384 regulator-min-microvolt = <1800000>;
385 regulator-max-microvolt = <3300000>;
386 regulator-always-on;
390 regulator-min-microvolt = <1800000>;
391 regulator-max-microvolt = <3300000>;
392 regulator-always-on;
396 regulator-min-microvolt = <1800000>;
397 regulator-max-microvolt = <3300000>;
398 regulator-always-on;
405 clock-frequency = <100000>;
406 pinctrl-names = "default";
407 pinctrl-0 = <&pinctrl_i2c3>;
413 interrupt-parent = <&gpio6>;
415 wakeup-gpios = <&gpio6 7 0>;
420 pinctrl-names = "default";
421 pinctrl-0 = <&pinctrl_hog>;
423 imx6qdl-sabresd {
637 lvds-channel@1 {
638 fsl,data-mapping = "spwg";
639 fsl,data-width = <18>;
646 remote-endpoint = <&panel_in>;
653 pinctrl-names = "default";
654 pinctrl-0 = <&pinctrl_pcie>;
655 reset-gpio = <&gpio7 12 GPIO_ACTIVE_LOW>;
656 vpcie-supply = <®_pcie>;
661 pinctrl-names = "default";
662 pinctrl-0 = <&pinctrl_pwm1>;
667 vin-supply = <&sw1a_reg>;
671 vin-supply = <&sw1c_reg>;
675 vin-supply = <&sw1c_reg>;
687 pinctrl-names = "default";
688 pinctrl-0 = <&pinctrl_uart1>;
693 vbus-supply = <®_usb_h1_vbus>;
698 vbus-supply = <®_usb_otg_vbus>;
699 pinctrl-names = "default";
700 pinctrl-0 = <&pinctrl_usbotg>;
701 disable-over-current;
706 pinctrl-names = "default";
707 pinctrl-0 = <&pinctrl_usdhc2>;
708 bus-width = <8>;
709 cd-gpios = <&gpio2 2 GPIO_ACTIVE_LOW>;
710 wp-gpios = <&gpio2 3 GPIO_ACTIVE_HIGH>;
715 pinctrl-names = "default";
716 pinctrl-0 = <&pinctrl_usdhc3>;
717 bus-width = <8>;
718 cd-gpios = <&gpio2 0 GPIO_ACTIVE_LOW>;
719 wp-gpios = <&gpio2 1 GPIO_ACTIVE_HIGH>;
724 pinctrl-names = "default";
725 pinctrl-0 = <&pinctrl_usdhc4>;
726 bus-width = <8>;
727 non-removable;
728 no-1-8-v;
737 pinctrl-names = "default";
738 pinctrl-0 = <&pinctrl_wdog>;
739 fsl,ext-reset-output;