arm/dts/imx6-logicpd-baseboard.dtsi

5  * This file is dual-licensed: you can use it either under the terms
46 		compatible = "gpio-keys";
52 			debounce-interval = <10>;
53 			wakeup-source;
60 			debounce-interval = <10>;
61 			wakeup-source;
68 			debounce-interval = <10>;
69 			wakeup-source;
75 			debounce-interval = <10>;
76 			wakeup-source;
82 		compatible = "gpio-leds";
86 			pinctrl-names = "default";
87 			pinctrl-0 = <&pinctrl_led0>;
89 			linux,default-trigger = "cpu0";
100 			linux,default-trigger = "heartbeat";
106 			linux,default-trigger = "default-on";
110 	reg_usb_otg_vbus: regulator-otg-vbus@0 {
111 		compatible = "regulator-fixed";
112 		regulator-name = "usb_otg_vbus";
113 		regulator-min-microvolt = <5000000>;
114 		regulator-max-microvolt = <5000000>;
115 		gpio = <&gpio4 15 GPIO_ACTIVE_HIGH>;
116 		enable-active-high;
119 	reg_usb_h1_vbus: regulator-usbh1vbus@1 {
120 		compatible = "regulator-fixed";
121 		regulator-name = "usb_h1_vbus";
122 		regulator-min-microvolt = <5000000>;
123 		regulator-max-microvolt = <5000000>;
126 	reg_3v3: regulator-3v3@2 {
127 		pinctrl-names = "default";
128 		pinctrl-0 = <&pinctrl_reg_3v3>;
129 		compatible = "regulator-fixed";
130 		regulator-name = "reg_3v3";
131 		regulator-min-microvolt = <3300000>;
132 		regulator-max-microvolt = <3300000>;
133 		gpio = <&gpio1 26 GPIO_ACTIVE_HIGH>;
134 		enable-active-high;
135 		regulator-always-on;
138 	reg_enet: regulator-ethernet@3 {
139 		pinctrl-names = "default";
140 		pinctrl-0 = <&pinctrl_enet_pwr>;
141 		compatible = "regulator-fixed";
142 		regulator-name = "ethernet-supply";
143 		regulator-min-microvolt = <3300000>;
144 		regulator-max-microvolt = <3300000>;
145 		gpio = <&gpio3 31 GPIO_ACTIVE_HIGH>;
146 		startup-delay-us = <70000>;
147 		enable-active-high;
148 		vin-supply = <&sw4_reg>;
151 	reg_audio: regulator-audio@4 {
152 		pinctrl-names = "default";
153 		pinctrl-0 = <&pinctrl_reg_audio>;
154 		compatible = "regulator-fixed";
155 		regulator-name = "3v3_aud";
156 		regulator-min-microvolt = <3300000>;
157 		regulator-max-microvolt = <3300000>;
158 		gpio = <&gpio1 29 GPIO_ACTIVE_HIGH>;
159 		enable-active-high;
160 		regulator-always-on;
161 		vin-supply = <&reg_3v3>;
164 	reg_hdmi: regulator-hdmi@5 {
165 		pinctrl-names = "default";
166 		pinctrl-0 = <&pinctrl_reg_hdmi>;
167 		compatible = "regulator-fixed";
168 		regulator-name = "hdmi-supply";
169 		regulator-min-microvolt = <3300000>;
170 		regulator-max-microvolt = <3300000>;
171 		gpio = <&gpio3 20 GPIO_ACTIVE_HIGH>;
172 		enable-active-high;
173 		vin-supply = <&reg_3v3>;
176 	reg_uart3: regulator-uart3@6 {
177 		pinctrl-names = "default";
178 		pinctrl-0 = <&pinctrl_reg_uart3>;
179 		compatible = "regulator-fixed";
180 		regulator-name = "uart3-supply";
181 		gpio = <&gpio1 28 GPIO_ACTIVE_HIGH>;
182 		enable-active-high;
183 		regulator-always-on;
184 		vin-supply = <&reg_3v3>;
187 	reg_1v8: regulator-1v8@7 {
188 		pinctrl-names = "default";
189 		pinctrl-0 = <&pinctrl_reg_1v8>;
190 		compatible = "regulator-fixed";
191 		regulator-name = "1v8-supply";
192 		gpio = <&gpio3 30 GPIO_ACTIVE_HIGH>;
193 		enable-active-high;
194 		regulator-always-on;
195 		vin-supply = <&reg_3v3>;
199 		compatible = "regulator-fixed";
200 		pinctrl-names = "default";
201 		pinctrl-0 = <&pinctrl_pcie_reg>;
202 		regulator-name = "MPCIE_3V3";
203 		regulator-min-microvolt = <3300000>;
204 		regulator-max-microvolt = <3300000>;
205 		gpio = <&gpio1 2 GPIO_ACTIVE_HIGH>;
206 		enable-active-high;
210 		compatible = "regulator-fixed";
211 		pinctrl-names = "default";
212 		pinctrl-0 = <&pinctrl_mipi_pwr>;
213 		regulator-name = "mipi_pwr_en";
214 		regulator-min-microvolt = <2800000>;
215 		regulator-max-microvolt = <2800000>;
216 		gpio = <&gpio3 19 GPIO_ACTIVE_HIGH>;
217 		enable-active-high;
221 		compatible = "fsl,imx-audio-wm8962";
222 		model = "wm8962-audio";
223 		ssi-controller = <&ssi2>;
224 		audio-codec = <&codec>;
225 		audio-routing =
232 		mux-int-port = <2>;
233 		mux-ext-port = <4>;
238 	pinctrl-names = "default";
239 	pinctrl-0 = <&pinctrl_audmux>;
244 	pinctrl-names = "default";
245 	pinctrl-0 = <&pinctrl_ecspi1>;
250 	pinctrl-names = "default";
251 	pinctrl-0 = <&pinctrl_pwm3>;
255 	pinctrl-names = "default";
256 	pinctrl-0 = <&pinctrl_uart3>;
261 	vbus-supply = <&reg_usb_h1_vbus>;
266 	vbus-supply = <&reg_usb_otg_vbus>;
267 	pinctrl-names = "default";
268 	pinctrl-0 = <&pinctrl_usbotg>;
269 	disable-over-current;
274 	pinctrl-names = "default";
275 	pinctrl-0 = <&pinctrl_enet>;
276 	phy-mode = "rgmii";
277 	phy-reset-duration = <10>;
278 	phy-reset-gpios = <&gpio1 24 GPIO_ACTIVE_LOW>;
279 	phy-supply = <&reg_enet>;
280 	interrupt-parent = <&gpio1>;
286 	pinctrl-names = "default";
287 	pinctrl-0 = <&pinctrl_usdhc2>;
288 	pinctrl-1 = <&pinctrl_usdhc2_100mhz>;
289 	pinctrl-2 = <&pinctrl_usdhc2_200mhz>;
290 	no-1-8-v;
291 	keep-power-in-suspend;
296 	pinctrl-names = "default";
297 	pinctrl-0 = <&pinctrl_i2c1>;
298 	clock-frequency = <400000>;
305 		clock-names = "xclk";
306 		DCVDD-supply = <&reg_audio>;
307 		DBVDD-supply = <&reg_audio>;
308 		AVDD-supply = <&reg_audio>;
309 		CPVDD-supply = <&reg_audio>;
310 		MICVDD-supply = <&reg_audio>;
311 		PLLVDD-supply = <&reg_audio>;
312 		SPKVDD1-supply = <&reg_audio>;
313 		SPKVDD2-supply = <&reg_audio>;
314 		gpio-cfg = <
328 		pinctrl-names = "default";
329 		pinctrl-0 = <&pinctrl_ov5640>;
332 		clock-names = "xclk";
333 		DOVDD-supply = <&mipi_pwr>;
334 		AVDD-supply = <&mipi_pwr>;
335 		DVDD-supply = <&mipi_pwr>;
336 		reset-gpios = <&gpio3 26 GPIO_ACTIVE_LOW>;
337 		powerdown-gpios = <&gpio3 27 GPIO_ACTIVE_HIGH>;
341 				remote-endpoint = <&mipi_csi2_in>;
342 				clock-lanes = <0>;
343 				data-lanes = <1 2>;
348 	pcf8575: gpio@20 {
349 		pinctrl-names = "default";
350 		pinctrl-0 = <&pinctrl_pcf8574>;
353 		interrupt-parent = <&gpio6>;
355 		gpio-controller;
356 		#gpio-cells = <2>;
357 		interrupt-controller;
358 		#interrupt-cells = <2>;
359 		lines-initial-states = <0x0710>;
360 		wakeup-source;
371 			remote-endpoint = <&ov5640_to_mipi_csi2>;
372 			clock-lanes = <0>;
373 			data-lanes = <1 2>;
379 	pinctrl-names = "default";
380 	pinctrl-0 = <&pinctrl_pcie>;
381 	reset-gpio = <&gpio1 9 GPIO_ACTIVE_LOW>;
383 	vpcie-supply = <&reg_pcie>;
384 	/* fsl,max-link-speed = <2>; */
469 	pinctrl_usdhc2_100mhz: h100-usdhc2-100mhz {
481 	pinctrl_usdhc2_200mhz: h100-usdhc2-200mhz {
516 	pinctrl_reg_audio: audio-reg {
535 	pinctrl_pcf8574: pcf8575-pins {
579 	pinctrl_reg_3v3: reg-3v3 {
585 	pinctrl_reg_1v8: reg-1v8 {