Lines Matching +full:vl +full:- +full:supply
12 /dts-v1/;
13 #include <dt-bindings/gpio/gpio.h>
14 #include <dt-bindings/interrupt-controller/irq.h>
15 #include <dt-bindings/input/input.h>
51 stdout-path = "serial3:115200n8";
59 samsung,bl1-offset = <0x1400>;
60 samsung,bl2-offset = <0x3400>;
61 u-boot-memory = "/memory";
62 u-boot-offset = <0x3e00000 0x100000>;
67 #address-cells = <1>;
68 #size-cells = <1>;
69 pre-boot {
70 label = "bl1 pre-boot";
72 read-only;
74 type = "blob exynos-bl1";
81 read-only;
83 type = "blob exynos-bl2 boot,dtb";
84 payload = "/flash/ro-boot";
88 ro-boot {
89 label = "u-boot";
91 read-only;
97 i2c-arbitrator {
98 compatible = "i2c-arb-gpio-challenge";
99 #address-cells = <1>;
100 #size-cells = <0>;
102 i2c-parent = <&{/i2c@12CA0000}>;
104 our-claim-gpio = <&gpf0 3 GPIO_ACTIVE_LOW>;
105 their-claim-gpios = <&gpe0 4 GPIO_ACTIVE_LOW>;
106 slew-delay-us = <10>;
107 wait-retry-us = <3000>;
108 wait-free-us = <50000>;
113 #address-cells = <1>;
114 #size-cells = <0>;
116 battery: sbs-battery@b {
117 compatible = "sbs,sbs-battery";
119 sbs,poll-retry-count = <1>;
122 cros_ec: embedded-controller {
123 compatible = "google,cros-ec-i2c";
126 interrupt-parent = <&gpx1>;
127 wakeup-source;
128 i2c-max-frequency = <100000>;
129 u-boot,i2c-offset-len = <0>;
130 ec-interrupt = <&gpx1 6 GPIO_ACTIVE_LOW>;
133 power-regulator {
139 ti,enable-ext-control;
142 ti,enable-ext-control;
145 ti,enable-ext-control;
148 regulator-name = "vcd_led";
149 ti,overcurrent-wait = <3>;
152 regulator-name = "video_mid";
153 regulator-always-on;
154 ti,overcurrent-wait = <3>;
157 regulator-name = "wwan_r";
158 regulator-always-on;
159 ti,overcurrent-wait = <3>;
162 regulator-name = "sdcard";
163 ti,overcurrent-wait = <3>;
166 regulator-name = "camout";
167 regulator-always-on;
168 ti,overcurrent-wait = <3>;
171 regulator-name = "lcd_vdd";
172 ti,overcurrent-wait = <3>;
175 regulator-name = "video_mid_1a";
176 regulator-always-on;
177 ti,overcurrent-wait = <3>;
186 compatible = "ti,tps65090-charger";
193 ptn3460: lvds-bridge@20 {
196 sleep-gpios = <&gpy2 5 GPIO_ACTIVE_LOW>;
197 reset-gpios = <&gpx1 5 GPIO_ACTIVE_LOW>;
198 hotplug-gpios = <&gpx0 7 GPIO_ACTIVE_HIGH>;
199 edid-emulation = <5>;
204 remote-endpoint = <&panel_in>;
210 remote-endpoint = <&dp_out>;
219 #sound-dai-cells = <1>;
224 clock-frequency = <100000>;
227 u-boot,i2c-offset-len = <0>;
233 spi-max-frequency = <50000000>;
235 compatible = "spi-flash";
241 compatible = "pwm-backlight";
243 brightness-levels = <0 100 500 1000 1500 2000 2500 2800>;
244 default-brightness-level = <7>;
245 enable-gpios = <&gpx3 0 GPIO_ACTIVE_HIGH>;
246 power-supply = <&fet1>;
251 power-supply = <&fet6>;
256 remote-endpoint = <&bridge_out>;
262 spi-max-frequency = <1000000>;
263 spi-deactivate-delay = <100>;
266 embedded-controller {
267 compatible = "google,cros-ec-i2c";
269 spi-max-frequency = <5000000>;
270 ec-interrupt = <&gpx1 6 GPIO_ACTIVE_LOW>;
271 optimise-flash-write;
277 compatible = "google,snow-audio-max98095";
279 samsung,model = "Snow-I2S-MAX98095";
280 samsung,audio-codec = <&max98095>;
281 codec-enable-gpio = <&gpx1 7 GPIO_ACTIVE_HIGH>;
284 sound-dai = <&i2s0 0>;
288 sound-dai = <&max98095 0>;
304 samsung,bus-width = <8>;
314 samsung,bus-width = <4>;
324 samsung,vbus-gpio = <&gpx1 1 GPIO_ACTIVE_HIGH>;
329 samsung,vbus-gpio = <&gpx2 7 GPIO_ACTIVE_HIGH>;
333 samsung,min-temp = <25>;
334 samsung,max-temp = <125>;
335 samsung,start-warning = <95>;
336 samsung,start-tripping = <105>;
337 samsung,hw-tripping = <110>;
338 samsung,efuse-min-value = <40>;
339 samsung,efuse-value = <55>;
340 samsung,efuse-max-value = <100>;
342 samsung,dc-value = <25>;
346 samsung,vl-freq = <60>;
347 samsung,vl-col = <1366>;
348 samsung,vl-row = <768>;
349 samsung,vl-width = <1366>;
350 samsung,vl-height = <768>;
352 samsung,vl-clkp;
353 samsung,vl-dp;
354 samsung,vl-hsp;
355 samsung,vl-vsp;
357 samsung,vl-bpix = <4>;
359 samsung,vl-hspw = <32>;
360 samsung,vl-hbpd = <80>;
361 samsung,vl-hfpd = <48>;
362 samsung,vl-vspw = <5>;
363 samsung,vl-vbpd = <14>;
364 samsung,vl-vfpd = <3>;
365 samsung,vl-cmd-allow-len = <0xf>;
368 samsung,interface-mode = <1>;
369 samsung,dp-enabled = <1>;
370 samsung,dual-lcd-enabled = <0>;
374 samsung,lt-status = <0>;
376 samsung,master-mode = <0>;
377 samsung,bist-mode = <0>;
378 samsung,bist-pattern = <0>;
379 samsung,h-sync-polarity = <0>;
380 samsung,v-sync-polarity = <0>;
382 samsung,color-space = <0>;
383 samsung,dynamic-range = <0>;
384 samsung,ycbcr-coeff = <0>;
385 samsung,color-depth = <1>;
386 samsung,hpd-gpio = <&gpx0 7 GPIO_ACTIVE_HIGH>;
391 remote-endpoint = <&bridge_in>;
401 samsung,i2c-sda-delay = <100>;
402 samsung,i2c-max-bus-freq = <378000>;
406 interrupt-parent = <&gpx3>;
408 wakeup-source;
410 #clock-cells = <1>;
412 voltage-regulators {
414 regulator-name = "P1.0V_LDO_OUT1";
415 regulator-min-microvolt = <1000000>;
416 regulator-max-microvolt = <1000000>;
417 regulator-always-on;
421 regulator-name = "P1.8V_LDO_OUT2";
422 regulator-min-microvolt = <1800000>;
423 regulator-max-microvolt = <1800000>;
424 regulator-always-on;
428 regulator-name = "P1.8V_LDO_OUT3";
429 regulator-min-microvolt = <1800000>;
430 regulator-max-microvolt = <1800000>;
431 regulator-always-on;
435 regulator-name = "P1.1V_LDO_OUT7";
436 regulator-min-microvolt = <1100000>;
437 regulator-max-microvolt = <1100000>;
438 regulator-always-on;
442 regulator-name = "P1.0V_LDO_OUT8";
443 regulator-min-microvolt = <1000000>;
444 regulator-max-microvolt = <1000000>;
445 regulator-always-on;
449 regulator-name = "P1.8V_LDO_OUT10";
450 regulator-min-microvolt = <1800000>;
451 regulator-max-microvolt = <1800000>;
452 regulator-always-on;
456 regulator-name = "P3.0V_LDO_OUT12";
457 regulator-min-microvolt = <3000000>;
458 regulator-max-microvolt = <3000000>;
459 regulator-always-on;
463 regulator-name = "P1.8V_LDO_OUT14";
464 regulator-min-microvolt = <1800000>;
465 regulator-max-microvolt = <1800000>;
466 regulator-always-on;
470 regulator-name = "P1.0V_LDO_OUT15";
471 regulator-min-microvolt = <1000000>;
472 regulator-max-microvolt = <1000000>;
473 regulator-always-on;
477 regulator-name = "P1.8V_LDO_OUT16";
478 regulator-min-microvolt = <1800000>;
479 regulator-max-microvolt = <1800000>;
480 regulator-always-on;
484 regulator-name = "vdd_mydp";
485 regulator-min-microvolt = <1200000>;
486 regulator-max-microvolt = <1200000>;
490 regulator-name = "vdd_mif";
491 regulator-min-microvolt = <950000>;
492 regulator-max-microvolt = <1300000>;
493 regulator-always-on;
494 regulator-boot-on;
498 regulator-name = "vdd_arm";
499 regulator-min-microvolt = <850000>;
500 regulator-max-microvolt = <1350000>;
501 regulator-always-on;
502 regulator-boot-on;
506 regulator-name = "vdd_int";
507 regulator-min-microvolt = <900000>;
508 regulator-max-microvolt = <1200000>;
509 regulator-always-on;
510 regulator-boot-on;
514 regulator-name = "vdd_g3d";
515 regulator-min-microvolt = <850000>;
516 regulator-max-microvolt = <1300000>;
517 regulator-always-on;
518 regulator-boot-on;
522 regulator-name = "P1.8V_BUCK_OUT5";
523 regulator-min-microvolt = <1800000>;
524 regulator-max-microvolt = <1800000>;
525 regulator-always-on;
526 regulator-boot-on;
530 regulator-name = "P1.35V_BUCK_OUT6";
531 regulator-min-microvolt = <1350000>;
532 regulator-max-microvolt = <1350000>;
533 regulator-always-on;
537 regulator-name = "P2.0V_BUCK_OUT7";
538 regulator-min-microvolt = <2000000>;
539 regulator-max-microvolt = <2000000>;
540 regulator-always-on;
544 regulator-name = "P2.85V_BUCK_OUT8";
545 regulator-min-microvolt = <2850000>;
546 regulator-max-microvolt = <2850000>;
547 regulator-always-on;
553 #include "cros-ec-keyboard.dtsi"