arm/dts/at91sam9x5ek.dtsi

2  * at91sam9x5ek.dtsi - Device Tree file for AT91SAM9x5CM Base board
12 	model = "Atmel AT91SAM9X5-EK";
17 		stdout-path = "serial0:115200n8";
18 		u-boot,dm-pre-reloc;
23 			mmc0: mmc@f0008000 {
24 				pinctrl-0 = <
29 				slot@0 {
31 					bus-width = <4>;
32 					cd-gpios = <&pioD 15 GPIO_ACTIVE_HIGH>;
36 			mmc1: mmc@f000c000 {
37 				pinctrl-0 = <
42 				slot@0 {
44 					bus-width = <4>;
45 					cd-gpios = <&pioD 14 GPIO_ACTIVE_HIGH>;
50 				u-boot,dm-pre-reloc;
59 				pinctrl-names = "default";
60 				pinctrl-0 = <&pinctrl_board_usb2>;
61 				atmel,vbus-gpio = <&pioB 16 GPIO_ACTIVE_HIGH>;
75 				atmel,adc-ts-wires = <4>;
76 				atmel,adc-ts-pressure-threshold = <10000>;
82 					pinctrl_pck0_as_isi_mck: pck0_as_isi_mck-0 {
87 					pinctrl_sensor_power: sensor_power-0 {
92 					pinctrl_sensor_reset: sensor_reset-0 {
99 					pinctrl_board_mmc0: mmc0-board {
106 					pinctrl_board_mmc1: mmc1-board {
113 					pinctrl_board_usb2: usb2-board {
120 			spi0: spi@f0000000 {
122 				cs-gpios = <&pioA 14 0>, <0>, <0>, <0>;
124 					compatible = "spi-flash";
125 					spi-max-frequency = <50000000>;
141 			num-ports = <3>;
142 			atmel,vbus-gpio = <0 /* &pioD 18 GPIO_ACTIVE_LOW *//* Activate to have access to port A */
154 		compatible = "atmel,sam9x5-wm8731-audio";
158 		atmel,audio-routing =
164 		atmel,ssc-controller = <&ssc0>;
165 		atmel,audio-codec = <&wm8731>;