arm/dts/at91sam9263ek.dts

2  * at91sam9263ek.dts - Device Tree file for Atmel at91sam9263 reference board
4  *  Copyright (C) 2012 Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
8 /dts-v1/;
16 		bootargs = "mem=64M root=/dev/mtdblock5 rw rootfstype=ubifs";
17 		stdout-path = "serial0:115200n8";
18 		u-boot,dm-pre-reloc;
27 			clock-frequency = <32768>;
31 			clock-frequency = <16367660>;
38 				u-boot,dm-pre-reloc;
43 				pinctrl-0 = <
51 				phy-mode = "rmii";
56 				atmel,vbus-gpio = <&pioA 25 GPIO_ACTIVE_HIGH>;
61 				pinctrl-0 = <
69 					bus-width = <4>;
70 					cd-gpios = <&pioE 18 GPIO_ACTIVE_HIGH>;
71 					wp-gpios = <&pioE 19 GPIO_ACTIVE_HIGH>;
77 					pinctrl_board_mmc0: mmc0-board {
87 				cs-gpios = <&pioA 5 0>, <0>, <0>, <0>;
90 					spi-max-frequency = <15000000>;
105 				bits-per-pixel = <16>;
106 				atmel,lcdcon-backlight;
109 				atmel,guard-time = <1>;
111 				display-timings {
112 					native-mode = <&timing0>;
114 						clock-frequency = <4965000>;
117 						hback-porch = <1>;
118 						hfront-porch = <33>;
119 						vback-porch = <1>;
120 						vfront-porch = <0>;
121 						hsync-len = <5>;
122 						vsync-len = <1>;
123 						hsync-active = <1>;
124 						vsync-active = <1>;
131 			nand-bus-width = <8>;
132 			nand-ecc-mode = "soft";
133 			nand-on-flash-bbt = <1>;
178 			num-ports = <2>;
180 			atmel,vbus-gpio = <&pioA 24 GPIO_ACTIVE_HIGH
187 		compatible = "gpio-leds";
191 			gpios = <&pioB 7 GPIO_ACTIVE_HIGH>;
192 			linux,default-trigger = "heartbeat";
197 			gpios = <&pioC 29 GPIO_ACTIVE_LOW>;
198 			linux,default-trigger = "nand-disk";
203 		compatible = "gpio-keys";
207 			gpios = <&pioC 5 GPIO_ACTIVE_LOW>;
209 			wakeup-source;
214 			gpios = <&pioC 4 GPIO_ACTIVE_LOW>;
216 			wakeup-source;
220 	i2c-gpio-0 {