arm/dts/at91-sama5d2_ptc_ek.dts

2  * at91-sama5d2_ptc_ek.dts - Device Tree file for SAMA5D2 PTC EK board
7  * This file is dual-licensed: you can use it either under the terms
45 /dts-v1/;
46 #include <dt-bindings/gpio/gpio.h>
47 #include "sama5d2.dtsi"
48 #include "sama5d2-pinfunc.h"
51 	model = "Atmel SAMA5D2 PTC EK";
52 	compatible = "atmel,sama5d2-ptc_ek", "atmel,sama5d2", "atmel,sama5";
55 		u-boot,dm-pre-reloc;
56 		stdout-path = &uart0;
61 		pinctrl-names = "default";
62 		pinctrl-0 = <&pinctrl_onewire_tm_default>;
73 			atmel,vbus-gpio = <&pioA PIN_PA27 GPIO_ACTIVE_HIGH>;
74 			pinctrl-names = "default";
75 			pinctrl-0 = <&pinctrl_usba_vbus>;
80 			num-ports = <3>;
81 			atmel,vbus-gpio = <0
85 			pinctrl-names = "default";
86 			pinctrl-0 = <&pinctrl_usb_default>;
94 		sdmmc0: sdio-host@a0000000 {
95 			bus-width = <8>;
96 			pinctrl-names = "default";
97 			pinctrl-0 = <&pinctrl_sdmmc0_cmd_dat_default &pinctrl_sdmmc0_ck_cd_default>;
99 			u-boot,dm-pre-reloc;
102 		sdmmc1: sdio-host@b0000000 {
103 			bus-width = <4>;
104 			pinctrl-names = "default";
105 			pinctrl-0 = <&pinctrl_sdmmc1_cmd_dat_default &pinctrl_sdmmc1_ck_cd_default>;
107 			u-boot,dm-pre-reloc;
112 				pinctrl-names = "default";
113 				pinctrl-0 = <&pinctrl_macb0_rmii &pinctrl_macb0_phy_irq>;
114 				phy-mode = "rmii";
117 				ethernet-phy@1 {
123 				pinctrl-names = "default";
124 				pinctrl-0 = <&pinctrl_uart0_default>;
126 				u-boot,dm-pre-reloc;
129 			i2c1: i2c@fc028000 {
130 				pinctrl-names = "default";
131 				pinctrl-0 = <&pinctrl_i2c1_default>;
145 						bias-disable;
150 						bias-disable;
164 						bias-disable;
177 						bias-pull-up;
178 						u-boot,dm-pre-reloc;
186 						bias-disable;
187 						u-boot,dm-pre-reloc;
196 						bias-pull-up;
197 						u-boot,dm-pre-reloc;
203 						bias-disable;
204 						u-boot,dm-pre-reloc;
210 						bias-disable;
211 						u-boot,dm-pre-reloc;
216 						bias-disable;
221 						bias-disable;
226 						bias-pull-up;