arm/dts/armada-3720-uDPU.dts

1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
4  * Based on Marvell Armada 3720 development board (DB-88F3720-DDR3)
12 /dts-v1/;
14 #include "armada-37xx.dtsi"
15 #include "armada-3720-uDPU-u-boot.dtsi"
22 		stdout-path = "serial0:115200n8";
38 		#address-cells = <1>;
39 		#size-cells = <0>;
40 		ethphy0: ethernet-phy@0 {
43 		ethphy1: ethernet-phy@1 {
49 		compatible = "marvell,mvebu-scsi";
50 		#address-cells = <1>;
51 		#size-cells = <1>;
52 		max-id = <1>;
53 		max-lun = <1>;
58 		compatible = "marvell,armada-3700-i2c", "simple-bus";
60 		pinctrl-names = "default";
61 		pinctrl-0 = <&i2c2_pins>;
62 		#address-cells = <2>;
63 		#size-cells = <2>;
68 		compatible = "marvell,armada-3700-uart-ext";
70 		pinctrl-names = "default";
71 		pinctrl-0 = <&uart2_pins>;
74 		#address-cells = <2>;
75 		#size-cells = <2>;
79 		compatible = "regulator-gpio";
80 		regulator-name = "vcc_sd0";
81 		regulator-min-microvolt = <1800000>;
82 		regulator-max-microvolt = <3300000>;
83 		regulator-type = "voltage";
89 	sfp_eth0: sfp-eth0 {
91 		i2c-bus = <&i2c0>;
92 		los-gpio = <&gpiosb 2 GPIO_ACTIVE_HIGH>;
93 		mod-def0-gpio = <&gpiosb 3 GPIO_ACTIVE_LOW>;
94 		tx-disable-gpio = <&gpiosb 4 GPIO_ACTIVE_HIGH>;
95 		tx-fault-gpio = <&gpiosb 5 GPIO_ACTIVE_HIGH>;
98 	sfp_eth1: sfp-eth1 {
100 		i2c-bus = <&i2c1>;
102 		los-gpio = <&gpiosb 7 GPIO_ACTIVE_HIGH>;
103 		mod-def0-gpio = <&gpiosb 8 GPIO_ACTIVE_LOW>;
104 		tx-disable-gpio = <&gpiosb 9 GPIO_ACTIVE_HIGH>;
105 		tx-fault-gpio = <&gpiosb 10 GPIO_ACTIVE_HIGH>;
111 		phy-type = <PHY_TYPE_SGMII1>;
112 		phy-speed = <PHY_SPEED_1_25G>;
115                 phy-type = <PHY_TYPE_SGMII0>;
116                 phy-speed = <PHY_SPEED_1_25G>;
120                 phy-type = <PHY_TYPE_USB3_HOST1>;
121                 phy-speed = <PHY_SPEED_5G>;
126 	pinctrl-0 = <&pcie_pins>;
128 	phy-mode = "sgmii";
130 	fixed-link {
132 		full-duplex;
138 	phy-mode = "sgmii";
140 	fixed-link {
142 		full-duplex;
147         pinctrl-names = "default";
148         pinctrl-0 = <&i2c1_pins>;
154 	pinctrl-names = "default";
155 	pinctrl-0 = <&spi_quad_pins>;
157 	spi-flash@0 {
158 		#address-cells = <1>;
159 		#size-cells = <1>;
162 		spi-max-frequency = <50000000>;
163 		spi-rx-bus-width = <4>;
164 		spi-tx-bus-width = <4>;
165 		m25p,fast-read;
175 	non-removable;
176 	mmc-ddr-1_8v;
177 	mmc-hs200-1_8v;
178 	bus-width = <4>;
179 	vqmmc-supply = <&vcc_sd_reg0>;
180 	pinctrl-names = "default";
181 	pinctrl-0 = <&sdio_pins>;
184 	#address-cells = <1>;
185 	#size-cells = <0>;
187 		compatible = "mmc-card";
193 	pinctrl-names = "default";
194 	pinctrl-0 = <&uart1_pins>;