Lines Matching full:be

13 The system inventory can be generated from the MRW XML. The inventory typically
17 To specify a target in the MRW should be in the inventory:
21 **Note**: The BMC and cores will be automatically added without the need to set
26 The BMC device tree can be generated from the MRW XML. For the full device tree
27 to be generated, all of the corresponding devices and connections must be
29 XML representations, there are only a few attributes that need to be set. If a
30 new part is being modeled, initial values for some attributes may need to be
51 into the XML representation and don't need to be updated when the device is
67 To enable a BMC MAC module, its ethernet master unit in the MRW must be
69 need to be set.
73 This attribute in the ethernet master unit can be set to 1 if the link uses
78 This attribute in the ethernet master unit can be set to 1 if the MAC has
89 LEDS will be listed in the device tree when LED parts in the MRW are wired to
105 The 8 bit hexadecimal I2C address should be set in the slave unit of the end
110 When creating a new XML device model, this attribute should be used to specify
112 `ti,423` or `bosch,bmp280`. For existing parts, this should already be set.
117 an I2C device. It specifies which other attributes of the device should be
123 `ATTR_WRITE_PAGE_SIZE` attribute should be stored in a property called