docs/control/events.md

104 After invoking the configured method, any actions configured for this trigger
116 1. `get_properties` - Read the property configured for the group from every
125 configured group. After handling the signal, any configured actions are run.
161 Timer triggers run actions after the configured type of timer expires.
184 Optional, if set to true, will update the D-Bus properties from the configured
397 Sets the fans to a configured floor when a number of members within the group
398 are at a configured state. Once the number of members at the given state falls
399 below the configured count, the floor hold is released.
411 The above config reads the configured D-Bus property on each group member
412 configured for the action. If two or more members have a property value of false
418 Sets the fans to a configured target when a number of members within the group
419 are at a configured state. Once the number of members at the given state falls
420 below the configured count, active fan target changes are allowed.
431 The above config reads the configured D-Bus property on each group member
432 configured for the action. If one or more members have a property value of
526 Sets the fans to a configured target when any service owner associated to the
549 This action locks fans at configured targets when the configured `count` amount
566 one or more members in its configured group have a group property value of
579 It must be configured with the following groups and properties:
686 group will be mapped to the "map" to get the output "target". Each configured
699 When all groups have a configured value to compare against, that will be
704 When any group does not have a configured value to be compared against, the
783 the configured groups and then add all resulting property values to the object