Lines Matching full:default

21   GPU. ARM gets the remaining memory. Min 16. Default 64.
24   the 512MB RP. Overrides gpu_mem. Max 192. Default not set.
27   the 256MB RP. Overrides gpu_mem. Max 448. Default not set.
30   the 256MB/512MB RP. Overrides gpu_mem. Max 944. Default not set.
36 By default, each machine uses `vc4` for graphics. This will in turn sets mesa as provider for `gl` …
54 By default the GPU adds a black border around the video output to compensate for
62 By default a rainbow splash screen is shown after the GPU firmware is loaded.
70 before loading the kernel. By default it is one second. This is useful if your
80 By default SD card media is used as boot media.
84 The default value of `CMDLINE_ROOT_PARTITION` is "/dev/mmcblk0p2" to mount SD card. If you want to …
113 By default the video mode for these is autodetected on boot: the HDMI mode is
276 RaspberryPi 0, 1, 2 and CM will have UART console enabled by default.
278 RaspberryPi 0 WiFi and 3 does not have the UART enabled by default because this
301 By default in case of the Compute Module 4 IO Board the standard USB driver
310 By default Linux will use all available CPUs for scheduling tasks. For real time
340 …board. The frequency is usually marked on the package of the crystal. By default, it is set to 16 …
344 Configure the interrupt pin to the one connected to the CAN module. By default,
365 Appropriate kernel modules will be also included in the image. By default the
380 By default the feature uses gpio pin 3 (except RPi 1 Model B rev 1 enumerates
391 the default is GPIO 4. To enable the one-wire interface explicitly set it in
418 Raspberry Pi does not have the unicam device ( Raspberry Pi Camera ) enabled by default.
445 You may need to adjust volume and toggle switches that are off by default
487 MMAL is not enabled by default. To enable it add
491 to `local.conf`. Adding `vlc` to `IMAGE_INSTALL` will then default to building the oe-core