redfish/extended/test_escale_base.robot

28 #  The power limits are documented in
29 #  open-power/witherspoon-xml/master/witherspoon.xml.
36     [Documentation]  Run base power tests with DCMI power monitoring off.
39     Deactivate DCMI Power And Verify
40     Verify Power Limits
44     [Documentation]  Run base power tests with DCMI power monitoring on.
47     Activate DCMI Power And Verify
48     Verify Power Limits
51 Escale Power Setting Via REST And Verify
52     [Documentation]  Set power via REST and check using IPMI.
55     # A convenient power level bewtwwn maximum and minimum.
58     # Set the power limit via REST.
59     Set DCMI Power Limit Via REST  ${test_power}
61     # Read the power limit using IPMI.
62     ${power_limit}=  Get DCMI Power Limit
64     ...  msg=Reading Power limit with IPMI failed after setting it with REST.
67 Escale Power Setting Via IPMI And Verify
68     [Documentation]  Set power via IPMI then check via REST.
71     # A convenient power level bewtwwn maximum and minimum.
74     # Set DCMI Power via IPMI.
75     Set DCMI Power Limit And Verify  ${test_power}
78     ${power_limit}=  Get DCMI Power Limit Via REST
80     ...  msg=Reading power limit with REST failed after setting it with IPMI.
84     [Documentation]  Activate power monitoring via REST then check via IPMI.
87     Activate DCMI Power Via REST
89     Fail If DCMI Power Is Not Activated
93     [Documentation]  Deactivate power monitoring via REST and check via IPMI.
96     Deactivate DCMI Power Via REST
98     Fail If DCMI Power Is Not Deactivated
104 Verify Power Limits
105     [Documentation]  Set power levels and verify limits.
107     Set DCMI Power Limit And Verify  ${mid_power}
108     Test Power Limit  ${min_power}  ${below_min_power}
109     Test Power Limit  ${min_power}  ${zero_power}
110     Test Power Limit  ${max_power}  ${over_max_power}
112     ${power_limit}=  Get DCMI Power Limit
114     ...  msg=Power at ${power_limit}. Power should be at ${max_power}.
117 Test Power Limit
118     [Documentation]  Set power and check limit.
122     # good_power              A valid power setting, usually at a limit.
123     # outside_bounds_power    A power level that is beyond the limit.
125     Set DCMI Power Limit And Verify  ${good_power}
127     # Attempt set power limit out of range.
139     ${cmd}=  Catenate  dcmi power get_limit | grep State
141     # Response is either "Power Limit Active" or "No Active Power Limit".
146     # Save the power limit setting.
147     ${initial_power_setting}=  Get DCMI Power Limit
158     # Restore the system's initial power limit setting.
160     ...  Set DCMI Power Limit And Verify  ${initial_power_setting}
164     ...  Deactivate DCMI Power And Verify  ELSE  Activate DCMI Power And Verify