Lines Matching +full:rx +full:- +full:input +full:- +full:m

1 # SPDX-License-Identifier: GPL-2.0-only
3 	tristate "SoC Audio for the Tegra System-on-Chip"
10 	  Say Y or M here if you want support for SoC audio on Tegra.
19 	  Say Y or M if you want to add support for codecs attached to the
26 	  Say Y or M if you want to add support for the Tegra20 DAS module.
34 	  Say Y or M if you want to add support for codecs attached to the
41 	  Say Y or M if you want to add support for the Tegra20 SPDIF interface.
48 	  Say Y or M if you want to add support for the Tegra30 AHUB module.
56 	  Say Y or M if you want to add support for codecs attached to the
67 	  Say Y or M if you want to add support for Tegra210 AHUB module.
73 	  to interface with Pulse Density Modulation (PDM) input devices.
77 	  Say Y or M if you want to add support for Tegra210 DMIC module.
82 	  Config to enable the Inter-IC Sound (I2S) Controller which
83 	  implements full-duplex and bidirectional and single direction
84 	  point-to-point serial interfaces. It can interface with I2S
86 	  Say Y or M if you want to add support for Tegra210 I2S module.
95 	  Say Y or M if you want to add support for Tegra210 OPE module.
101 	  which converts the sampling frequency of the input signal from
107 	  Say Y or M if you want to add support for Tegra186 ASRC module.
113 	  converts the multi-bit Pulse Code Modulation (PCM) audio input to
114 	  oversampled 1-bit Pulse Density Modulation (PDM) output. From the
116 	  that up-samples the input to the desired sampling rate by
117 	  interpolation and then converts the oversampled PCM input to
118 	  the desired 1-bit output via Delta Sigma Modulation (DSM).
119 	  Say Y or M if you want to add support for Tegra186 DSPK module.
128 	  ADMA channel receiving data from AHUB pairs with an ADMAIF Rx
130 	  Say Y or M if you want to add support for Tegra210 ADMAIF module.
137 	  used in input or output signal path. It can be used either for
138 	  per-stream volume control or for master volume control.
139 	  Say Y or M if you want to add support for Tegra210 MVC module.
145 	  converts the sampling frequency of input signal to another
148 	  Say Y or M if you want to add support for Tegra210 SFC module.
154 	  four input streams (each of up to 16 channels) and generate
156 	  output frame by any combination of bytes from the input frames.
157 	  Say Y or M if you want to add support for Tegra210 AMX module.
163 	  input stream (up to 16 channels) and demultiplexes it into four
165 	  form output frames by any combination of bytes from the input
168 	  Say Y or M if you want to add support for Tegra210 ADX module.
174 	  audio streams. It supports mixing of up to 10 input streams,
177 	  input streams.
178 	  Say Y or M if you want to add support for Tegra210 Mixer module.
186 	  few things for Tegra audio. Most of the code is re-used from
198 	  Say Y or M here if you want to add support for SoC audio on Tegra
207 	  Say Y or M here if you want to add support for SoC audio on Tegra
216 	  Say Y or M here if you want to add support for SoC audio on Tegra
225 	  Say Y or M here if you want to add support for SoC audio on Tegra
236 	  Say Y or M here if you want to add support for SoC audio on Tegra
245 	  Say Y or M here if you want to add support for SoC audio on the
254 	  Say Y or M here if you want to add support for SoC audio on the
263 	  Say Y or M here if you want to add support for SoC audio on Tegra
272 	  Say Y or M here if you want to add support for SoC audio on Tegra
281 	  Say Y or M here if you want to add support for SoC audio on Tegra
290 	  Say Y or M here if you want to add support for SoC audio on Tegra