Lines Matching refs:option

20 	  This option allows you to choose whether you want to have support
46 	  command line 'zswap.enabled=' option.
80 	  command line 'zswap.compressor=' option.
142 	  command line 'zswap.zpool=' option.
204 	  This option enables code in the zsmalloc to collect various
215 	  This option sets the upper limit on the number of physical pages
220 	  Changing this option can alter the characteristics of size classes,
234 	   This option allows to select a slab allocator.
312 	  sanity-checking than others. This option is most effective with
388 	  This option changes the bootup default to heap randomization
401 	  userspace.  Enabling this config option allows you to request that
403 	  providing a huge performance boost.  If this option is not enabled,
409 	  Because of the obvious security issues, this option should only be
426 	  This option allows you to change some of the ways that
428 	  only have one option here selected by the architecture
435 	  This option is best suited for non-NUMA systems with
438 	  and it is the best option for smaller systems.
444 	  If unsure, choose this option (Flat Memory) over any other.
450 	  This will be the only option for some systems, including
453 	  This option provides efficient support for systems with
457 	  If unsure, choose "Flat Memory" over this option.
472 # be done on your architecture, select this option.  However,
476 # This option will also potentially produce smaller runtime code
484 # must select this option. This is usually for architecture platforms with
501 	  efficient option when sufficient kernel resources are available.
503 # Select this config option from the architecture Kconfig, if it is preferred
552 # eventually, we can have this option just 'select SPARSEMEM'
567 	  This option sets the default policy setting for memory hotplug
649 	  disable this option unless there really is a strong reason for
795 	  Trimming can be dynamically controlled through a sysctl option
800 	  This option specifies the initial value of this option.  The default
917 	  This option does not affect warning and error messages.
929 	  This option exposes some sysfs attributes to get information
949 	  This option enables memory changes tracking by introducing a
980 	  amount of time. If this option is set, large machines will bring up
1094 	  This option allows the disabling of the VM event counters
1233 	  This option enables the multi-gen LRU by default.
1239 	  Do not enable this option unless you plan to look at historical stats
1242 	  This option has a per-memcg and per-node memory overhead.