Lines Matching +full:dw +full:- +full:apb +full:- +full:ssi
1 # SPDX-License-Identifier: GPL-2.0-only
13 dynamic device discovery; some are even write-only or read-only.
17 chips, analog to digital (and d-to-a) converters, and more.
23 (half duplex), SSP, SSI, and PSP. This driver framework should
44 If your system has an master-capable SPI controller (which
56 by providing a high-level interface to send memory-like commands.
145 supports spi-mem interface.
224 this code to manage the per-word or per-transfer accesses to the
254 Flash over 1/2/4-bit wide bus. Enable this option if you have a
266 Flash over up to 8-bit wide bus. Enable this option if you have a
274 This enables dedicated general purpose SPI/Microwire1-compatible
275 master mode interface (SSI1) for CLPS711X-based CPUs.
292 tristate "Texas Instruments DaVinci/DA8x/OMAP-L/AM1x SoC SPI controller"
296 SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules.
307 bool "DMA support for DW SPI controller"
310 tristate "PCI interface driver for DW SPI core"
314 tristate "Memory-mapped io interface driver for DW SPI core"
318 tristate "Baikal-T1 SPI driver for DW SPI core"
322 Baikal-T1 SoC is equipped with three DW APB SSI-based MMIO SPI
325 part of the Baikal-T1 System Boot Controller has got a very
327 chip-select and Tx/Rx FIFO with just 8 words depth available.
328 The later one is normally connected to an external SPI-nor flash
332 bool "Directly mapped Baikal-T1 Boot SPI flash support"
336 Baikal-T1 System Boot Controller. It is a 16MB MMIO region, which
338 reading/writing data from/to it. Note that the system APB bus
341 time-critical tasks (like the SPI memory operations implemented
347 tristate "Diolan DLN-2 USB SPI adapter"
354 will be called spi-dln2.
367 The external bus unit (EBU) found on the FALC-ON SoC has SPI
394 supports the high-level SPI memory interface.
411 will be called hisi-kunpeng-spi.
430 supports the high-level SPI memory interface.
433 tristate "GPIO-based bitbanging SPI Master"
437 This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
468 will be called spi-ingenic.
489 will be called spi-intel-pci.
501 exposes the low level SPI-NOR opcodes to the software. Using
508 will be called spi-intel-platform.
511 tristate "J-Core SPI Master"
514 This enables support for the SPI master controller in the J-Core
553 tristate "ICP DAS LP-8841 SPI Controller for RTC"
557 DS-1302 real time clock.
560 LP-8x4x industrial computer.
563 tristate "Freescale MPC52xx SPI (non-PSC) controller support"
642 If built as a module, it will be called spi-microchip-core.
651 If built as a module, it will be called spi-microchip-core-qspi.
683 This enables support for SPI-NAND mode on the MediaTek NAND
685 is implemented as a SPI-MEM controller with pipelined ECC
697 supports the spi-mem interface.
707 supports spi-mem interface.
775 called as spi-pci1xxxx.
850 tristate "Renesas RPC-IF SPI driver"
853 SPI driver for Renesas R-Car Gen3 or RZ/G2 RPC-IF.
879 for serial peripheral interface (SPI) mini-core. SPI in master
892 yes to this option, support will be included for the built-in SPI
896 will be called spi-geni-qcom.
959 for connecting an SPI Flash memory over up to 8-bit wide bus.
994 supports spi-mem interface.
997 tristate "STMicroelectronics SPI SSC-based driver"
1022 called as spi-sunplus-sp7021.
1033 that use the de-facto standard SPI protocol.
1035 It also supports the new dual-bit and quad-bit SPI protocol.
1117 tristate "Analog Devices AD-FMCOMMS1-EBZ SPI-I2C-bridge driver"
1120 Support for the SPI-I2C bridge found on the Analog Devices
1121 AD-FMCOMMS1-EBZ board.
1192 select one or more specific mux-controller drivers.
1236 If your system has a slave-capable SPI controller, you can enable