Lines Matching +full:llp +full:- +full:based
1 # SPDX-License-Identifier: GPL-2.0-only
13 dynamic device discovery; some are even write-only or read-only.
17 chips, analog to digital (and d-to-a) converters, and more.
44 If your system has an master-capable SPI controller (which
56 by providing a high-level interface to send memory-like commands.
145 supports spi-mem interface.
206 based platforms. This driver works for both SPI master for SPI NOR
224 this code to manage the per-word or per-transfer accesses to the
254 Flash over 1/2/4-bit wide bus. Enable this option if you have a
266 Flash over up to 8-bit wide bus. Enable this option if you have a
274 This enables dedicated general purpose SPI/Microwire1-compatible
275 master mode interface (SSI1) for CLPS711X-based CPUs.
292 tristate "Texas Instruments DaVinci/DA8x/OMAP-L/AM1x SoC SPI controller"
296 SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules.
314 tristate "Memory-mapped io interface driver for DW SPI core"
318 tristate "Baikal-T1 SPI driver for DW SPI core"
322 Baikal-T1 SoC is equipped with three DW APB SSI-based MMIO SPI
325 part of the Baikal-T1 System Boot Controller has got a very
327 chip-select and Tx/Rx FIFO with just 8 words depth available.
328 The later one is normally connected to an external SPI-nor flash
332 bool "Directly mapped Baikal-T1 Boot SPI flash support"
336 Baikal-T1 System Boot Controller. It is a 16MB MMIO region, which
341 time-critical tasks (like the SPI memory operations implemented
347 tristate "Diolan DLN-2 USB SPI adapter"
354 will be called spi-dln2.
367 The external bus unit (EBU) found on the FALC-ON SoC has SPI
394 supports the high-level SPI memory interface.
411 will be called hisi-kunpeng-spi.
430 supports the high-level SPI memory interface.
433 tristate "GPIO-based bitbanging SPI Master"
437 This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
468 will be called spi-ingenic.
489 will be called spi-intel-pci.
501 exposes the low level SPI-NOR opcodes to the software. Using
508 will be called spi-intel-platform.
511 tristate "J-Core SPI Master"
514 This enables support for the SPI master controller in the J-Core
522 This driver supports the NS LM70 LLP Evaluation Board,
553 tristate "ICP DAS LP-8841 SPI Controller for RTC"
557 DS-1302 real time clock.
560 LP-8x4x industrial computer.
563 tristate "Freescale MPC52xx SPI (non-PSC) controller support"
642 If built as a module, it will be called spi-microchip-core.
651 If built as a module, it will be called spi-microchip-core-qspi.
683 This enables support for SPI-NAND mode on the MediaTek NAND
685 is implemented as a SPI-MEM controller with pipelined ECC
697 supports the spi-mem interface.
707 supports spi-mem interface.
775 called as spi-pci1xxxx.
850 tristate "Renesas RPC-IF SPI driver"
853 SPI driver for Renesas R-Car Gen3 or RZ/G2 RPC-IF.
879 for serial peripheral interface (SPI) mini-core. SPI in master
887 tristate "Qualcomm GENI based SPI controller"
890 This driver supports GENI serial engine based SPI controller in
892 yes to this option, support will be included for the built-in SPI
896 will be called spi-geni-qcom.
959 for connecting an SPI Flash memory over up to 8-bit wide bus.
973 ADI driver based on SPI for Spreadtrum SoCs.
994 supports spi-mem interface.
997 tristate "STMicroelectronics SPI SSC-based driver"
1022 called as spi-sunplus-sp7021.
1033 that use the de-facto standard SPI protocol.
1035 It also supports the new dual-bit and quad-bit SPI protocol.
1117 tristate "Analog Devices AD-FMCOMMS1-EBZ SPI-I2C-bridge driver"
1120 Support for the SPI-I2C bridge found on the Analog Devices
1121 AD-FMCOMMS1-EBZ board.
1192 select one or more specific mux-controller drivers.
1236 If your system has a slave-capable SPI controller, you can enable