197 		printk(KERN_EMERG "qlogicpti%d: mbox_command loop timeout #1\n",  in qlogicpti_mbox_command()
234 		printk(KERN_EMERG "qlogicpti%d: mbox_command[%04x] loop timeout #2\n",  in qlogicpti_mbox_command()
248 		printk(KERN_EMERG "qlogicpti%d: mbox_command[%04x] loop timeout #3\n",  in qlogicpti_mbox_command()
256 		printk(KERN_EMERG "qlogicpti%d: mbox_command[%04x] loop timeout #4\n",  in qlogicpti_mbox_command()
355 		printk(KERN_EMERG "qlogicpti%d: reset_hardware loop timeout\n",  in qlogicpti_reset_hardware()
383 		printk(KERN_EMERG "qlogicpti%d: Cannot execute ISP firmware.\n",  in qlogicpti_reset_hardware()
394 		printk(KERN_EMERG "qlogicpti%d: Cannot set initiator SCSI ID.\n",  in qlogicpti_reset_hardware()
409 		printk(KERN_EMERG "qlogicpti%d: Cannot init response queue.\n",  in qlogicpti_reset_hardware()
421 		printk(KERN_EMERG "qlogicpti%d: Cannot init request queue.\n",  in qlogicpti_reset_hardware()
512 		printk(KERN_EMERG "qlogicpti%d: Aieee, firmware checksum failed!",  in qlogicpti_load_firmware()
524 		printk(KERN_EMERG "qlogicpti%d: Cannot reset the ISP.", qpti->qpti_id);  in qlogicpti_load_firmware()
562 		printk(KERN_EMERG "qlogicpti%d: Cannot stop firmware for reload.\n",  in qlogicpti_load_firmware()
595 		printk(KERN_EMERG "qlogicpti%d: New firmware csum failure!\n",  in qlogicpti_load_firmware()
609 		printk(KERN_EMERG "qlogicpti%d: AboutFirmware cmd fails.\n",  in qlogicpti_load_firmware()
625 		printk(KERN_EMERG "qlogicpti%d: could not set clock rate.\n",  in qlogicpti_load_firmware()
1053 	printk(KERN_EMERG "qlogicpti%d: request queue overflow\n",  in qlogicpti_queuecommand_lck()
1122 		printk(KERN_EMERG "qlogicpti%d: unknown completion status 0x%04x\n",  in DEF_SCSI_QCMD()
1254 		printk(KERN_EMERG "qlogicpti%d: scsi abort failure: %x\n",  in qlogicpti_abort()
1280 		printk(KERN_EMERG "qlogicisp%d: scsi bus reset failure: %x\n",  in qlogicpti_reset()