Lines Matching +full:wakeup +full:- +full:event +full:- +full:action
2 # Copyright 2011-2020 NXP
9 # 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301 USA or on the
10 # worldwide web at http://www.gnu.org/licenses/old-licenses/gpl-2.0.txt.
12 # THE FILE IS DISTRIBUTED AS-IS, WITHOUT WARRANTY OF ANY KIND, AND THE
38 Following are some useful iw commands:-
45 iw dev mlan0 connect -w <SSID> [<freq in MHz>] [<bssid>] [key 0:abcde d:1123456789a]
55 iw dev mlan0 ibss join <SSID> <freq in MHz> [fixed-freq] [fixed-bssid] [key 0:abcde]
79 mount -t debugfs debugfs /debugfs
98 bss_mode = "Ad-hoc" | "Managed" | "Auto" | "Unknown"
100 mac_address = <6-byte adapter MAC address>
128 ps_state = <0/1/2/3, full power state/awake state/pre-sleep state/sleep state>
130 wakeup_dev_req = <0/1, wakeup device not required/required>
131 wakeup_tries = <wakeup device count, cleared when device awake>
137 timeout_cmd_act = <command action of the last timeout command>
139 last_cmd_act = <command action of the last several commands sent to device>
143 last_event = <event id of the last several events received from device>
144 last_event_index = <0 based last event index>
156 mp_rd_bitmap = <SDIO multi-port read bitmap>
157 mp_wr_bitmap = <SDIO multi-port write bitmap>
159 event_received = <0/1, no event to process/event received and yet to process>
203 iwpriv mlan0 memrdwr -0x7fff6000 -0x40000000
216 <length>: 4-20, multiples of 4
230 <condition>: bit 0 = 1 -- broadcast data
231 bit 1 = 1 -- unicast data
232 bit 2 = 1 -- mac event
233 bit 3 = 1 -- multicast data
234 [GPIO#]: pin number of GPIO used to wakeup the host.
235 GPIO pin# (e.g. 0-7) or 0xff (interface, e.g. SDIO
237 [gap]: the gap in milliseconds between wakeup signal and
238 wakeup event or 0xff for special setting (host
239 acknowledge required) when GPIO is used to wakeup host.
242 echo "-1" > hscfg : Cancel host sleep mode
249 to ack before sending wakeup event