Lines Matching +full:buck +full:- +full:boost
1 # SPDX-License-Identifier: GPL-2.0-only
45 tristate "Active-semi ACT8945A"
50 Support for the ACT8945A PMIC from Active-semi. This device
51 features three step-down DC/DC converters and four low-dropout
67 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
70 called sun4i-gpadc.
101 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
132 over at91-usart-serial driver and usart-spi-driver. Only one function
148 tristate "Atmel HLCDC (High-end LCD Controller)"
185 tristate "X-Powers AC100"
189 If you say Y here you get support for the X-Powers AC100 audio codec
200 tristate "X-Powers AXP series PMICs with I2C"
205 If you say Y here you get support for the X-Powers AXP series power
217 tristate "X-Powers AXP series PMICs with RSB"
221 If you say Y here you get support for the X-Powers AXP series power
234 sub-devices. This driver will instantiate additional drivers such
238 called cros-ec-dev.
344 usually found on PXA processors-based platforms. This includes
347 LEDs and battery-charger under the corresponding menus.
416 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
422 This adds support for the DA9150 integrated charger and fuel-gauge
432 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
433 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
443 This adds support for the power-off functionality and access to
468 such as push-button monitor, multiple ADC's for voltage and
518 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
522 mxs-lradc-adc for ADC readings
523 mxs-lradc-ts for touchscreen support
526 called mxs-lradc.
543 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
548 We communicate with the Hi6421 via memory-mapped I/O.
558 multi-functions, such as regulators, RTC, codec, Coulomb counter,
586 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
623 causes the designware-i2c driver to be builtin for the same reason.
650 causes the designware-i2c driver to be builtin for the same reason.
667 needs the designware-i2c driver to be builtin for the same reason.
691 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
700 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
713 multi-function device that exposes IPC, General Control
714 Register and P-unit access. In addition this creates devices
734 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
735 options must be selected to enable device-specific functions.
741 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
745 This is the core driver for the Janz CMOD-IO PCI MODULbus
760 will be called kempld-core.
772 battery-charger under the corresponding menus.
795 battery-charger under the corresponding menus.
806 MAX77836 Micro-USB ICs with battery charger.
891 This is a Power Management IC with 4 buck regulators, 9
892 low-dropout regulators, 8 GPIOs, RTC, watchdog etc. This driver
968 PMIC part includes 2-channel BUCKs and 2-channel LDOs
969 LDO part includes 4-channel LDOs
981 voltage supply, one general purpose LDO, and the USB Type-C & PD
982 controller complies with the latest USB Type-C and PD standards.
1004 The device supports multiple sub-devices like LED, HWMON and WDT.
1029 called ocelot-soc.
1074 certain e-book readers designed by the original design manufacturer
1078 tristate "Nokia Retu and Tahvo multi-function device"
1083 Retu and Tahvo are a multi-function devices found on Nokia
1094 so that function-specific drivers can bind to them.
1118 built-in PM8xxx PMIC chips.
1124 module. This will build a module called "pm8xxx-core".
1153 series as a module. The module will be called "qcom-spmi-pmic".
1162 To enable support for building sub-devices as modules,
1166 tristate "RDC R-321x southbridge"
1170 Say yes here if you want to have support for the RDC R-321x SoC
1194 sub-devices like charger, fuel gauge, flash LED, current source,
1195 LDO and Buck.
1205 efficiency buck converters and one LDO voltage regulator. The device
1218 through i2c interface. The device supports multiple sub-devices
1238 through I2C interface. The device supports multiple sub-devices
1252 through an SPI interface. The device supports multiple sub-devices
1253 including interrupts, LDO & DCDC regulators, and power on-key.
1284 module will be called sec-core.
1296 radio. This MFD driver connects the radio-si476x V4L2 module
1300 module will be called si476x-core.
1309 to be shared by all sub-devices.
1312 sub-devices represented by child nodes in Device Tree will be
1325 * SMARC-sAL28
1380 the Multi-Function Timer Pulse Unit 3 (MTU3a) hardware available
1386 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1397 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1410 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1440 GPIO: stmpe-gpio
1441 Keypad: stmpe-keypad
1442 Touchscreen: stmpe-ts
1443 ADC: stmpe-adc
1549 tristate "TI TPS61050/61052 Boost Converters"
1557 high-power "white LED driver". This boost converter is
1757 will be called tps6594-i2c.
1770 will be called tps6594-spi.
1781 so that function-specific drivers can bind to them.
1783 These multi-function chips are found on many OMAP2 and OMAP3
1797 This driver uses board-specific data to initialize the resources
1827 regulators, Dual slot memory card transceivers, real-time clock
1838 driver connects the radio-wl1273 V4L2 module and the wl1273
1852 backlight or ambient-light-sensor functionality of the device.
1863 for in-vehicle infontainment, called Russellville.
1878 tristate "TQ-Systems IO controller TQMX86"
1882 TQ-Systems IO controller and watchdog device, found on their
2019 The WM8994 is a highly integrated hi-fi CODEC designed for
2033 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
2047 in various ST Microelectronics and ST-Ericsson embedded
2060 NXP i.MX8. It contains 8 BUCK outputs and 7 LDOs, voltage monitoring
2072 Power Management ICs. BD71828GW and BD71815AGW are single-chip power
2073 management ICs mainly for battery-powered portable devices.
2074 The BD71828 integrates 7 buck converters and 7 LDOs. The BD71815
2075 has 5 bucks, 7 LDOs, and a boost for driving LEDs. Both ICs provide
2076 also a single-cell linear charger, a Coulomb counter, a real-time
2089 designed to be used to power R-Car series processors.
2092 tristate "Support for STM32 Low-Power Timer"
2098 Select this option to enable STM32 Low-Power Timer driver
2103 module will be called stm32-lptimer.
2133 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2139 Support for the STMicroelectronics Multi-Function eXpander.
2189 power-on options, power-off control and system FAN control on recent
2269 This option enables basic support for the SGI IOC3-based