dts/renesas/r8a779g0-white-hawk-cpu.dtsi

1 // SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
10 #include <dt-bindings/gpio/gpio.h>
11 #include <dt-bindings/input/input.h>
12 #include <dt-bindings/leds/common.h>
16 	compatible = "renesas,white-hawk-cpu", "renesas,r8a779g0";
25 		stdout-path = "serial0:921600n8";
29 		compatible = "gpio-keys";
31 		pinctrl-0 = <&keys_pins>;
32 		pinctrl-names = "default";
34 		key-1 {
38 			wakeup-source;
39 			debounce-interval = <20>;
42 		key-2 {
46 			wakeup-source;
47 			debounce-interval = <20>;
50 		key-3 {
54 			wakeup-source;
55 			debounce-interval = <20>;
60 		compatible = "gpio-leds";
62 		led-1 {
66 			function-enumerator = <1>;
69 		led-2 {
73 			function-enumerator = <2>;
76 		led-3 {
80 			function-enumerator = <3>;
100 	mini-dp-con {
101 		compatible = "dp-connector";
107 				remote-endpoint = <&sn65dsi86_out>;
112 	reg_1p2v: regulator-1p2v {
113 		compatible = "regulator-fixed";
114 		regulator-name = "fixed-1.2V";
115 		regulator-min-microvolt = <1200000>;
116 		regulator-max-microvolt = <1200000>;
117 		regulator-boot-on;
118 		regulator-always-on;
121 	reg_1p8v: regulator-1p8v {
122 		compatible = "regulator-fixed";
123 		regulator-name = "fixed-1.8V";
124 		regulator-min-microvolt = <1800000>;
125 		regulator-max-microvolt = <1800000>;
126 		regulator-boot-on;
127 		regulator-always-on;
130 	reg_3p3v: regulator-3p3v {
131 		compatible = "regulator-fixed";
132 		regulator-name = "fixed-3.3V";
133 		regulator-min-microvolt = <3300000>;
134 		regulator-max-microvolt = <3300000>;
135 		regulator-boot-on;
136 		regulator-always-on;
139 	sn65dsi86_refclk: clk-x6 {
140 		compatible = "fixed-clock";
141 		#clock-cells = <0>;
142 		clock-frequency = <38400000>;
147 	pinctrl-0 = <&avb0_pins>;
148 	pinctrl-names = "default";
149 	phy-handle = <&phy0>;
150 	tx-internal-delay-ps = <2000>;
153 	phy0: ethernet-phy@0 {
154 		compatible = "ethernet-phy-id0022.1622",
155 			     "ethernet-phy-ieee802.3-c22";
156 		rxc-skew-ps = <1500>;
158 		interrupt-parent = <&gpio7>;
160 		reset-gpios = <&gpio7 10 GPIO_ACTIVE_LOW>;
170 				remote-endpoint = <&sn65dsi86_in>;
171 				data-lanes = <1 2 3 4>;
182 	clock-frequency = <16666666>;
186 	clock-frequency = <32768>;
190 	pinctrl-0 = <&hscif0_pins>;
191 	pinctrl-names = "default";
197 	pinctrl-0 = <&i2c0_pins>;
198 	pinctrl-names = "default";
201 	clock-frequency = <400000>;
206 		interrupt-parent = <&gpio0>;
208 		gpio-controller;
209 		#gpio-cells = <2>;
210 		interrupt-controller;
211 		#interrupt-cells = <2>;
216 		label = "cpu-board";
223 	pinctrl-0 = <&i2c1_pins>;
224 	pinctrl-names = "default";
227 	clock-frequency = <400000>;
234 		clock-names = "refclk";
236 		interrupt-parent = <&intc_ex>;
239 		enable-gpios = <&gpio1 26 GPIO_ACTIVE_HIGH>;
241 		vccio-supply = <&reg_1p8v>;
242 		vpll-supply = <&reg_1p8v>;
243 		vcca-supply = <&reg_1p2v>;
244 		vcc-supply = <&reg_1p2v>;
247 			#address-cells = <1>;
248 			#size-cells = <0>;
253 					remote-endpoint = <&dsi0_out>;
260 					remote-endpoint = <&mini_dp_con_in>;
268 	pinctrl-0 = <&mmc_pins>;
269 	pinctrl-1 = <&mmc_pins>;
270 	pinctrl-names = "default", "state_uhs";
272 	vmmc-supply = <&reg_3p3v>;
273 	vqmmc-supply = <&reg_1p8v>;
274 	mmc-hs200-1_8v;
275 	mmc-hs400-1_8v;
276 	bus-width = <8>;
277 	no-sd;
278 	no-sdio;
279 	non-removable;
280 	full-pwr-cycle-in-suspend;
285 	pinctrl-0 = <&scif_clk_pins>;
286 	pinctrl-names = "default";
297 			drive-strength = <21>;
302 			drive-strength = <21>;
323 		bias-pull-up;
329 		power-source = <1800>;
344 	pinctrl-0 = <&qspi0_pins>;
345 	pinctrl-names = "default";
350 		compatible = "spansion,s25fs512s", "jedec,spi-nor";
352 		spi-max-frequency = <40000000>;
353 		spi-rx-bus-width = <4>;
356 			compatible = "fixed-partitions";
357 			#address-cells = <1>;
358 			#size-cells = <1>;
362 				read-only;
372 	timeout-sec = <60>;
377 	clock-frequency = <24000000>;