dts/qcom/qcom-msm8974-sony-xperia-rhine.dtsi

1 // SPDX-License-Identifier: GPL-2.0
2 #include "qcom-msm8974.dtsi"
5 #include <dt-bindings/input/input.h>
6 #include <dt-bindings/leds/common.h>
7 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
15 		stdout-path = "serial0:115200n8";
18 	gpio-keys {
19 		compatible = "gpio-keys";
21 		pinctrl-names = "default";
22 		pinctrl-0 = <&gpio_keys_pin_a>;
24 		key-volume-down {
27 			linux,input-type = <1>;
31 		key-camera-snapshot {
34 			linux,input-type = <1>;
38 		key-camera-focus {
41 			linux,input-type = <1>;
45 		key-volume-up {
48 			linux,input-type = <1>;
53 	reserved-memory {
54 		#address-cells = <1>;
55 		#size-cells = <1>;
62 			console-size = <0x100000>;
63 			record-size = <0x10000>;
64 			ftrace-size = <0x10000>;
65 			pmsg-size = <0x80000>;
72 	clock-frequency = <355000>;
75 		compatible = "syna,rmi4-i2c";
78 		interrupts-extended = <&tlmm 61 IRQ_TYPE_EDGE_FALLING>;
80 		#address-cells = <1>;
81 		#size-cells = <0>;
83 		vdd-supply = <&pm8941_l22>;
84 		vio-supply = <&pm8941_lvs3>;
86 		pinctrl-names = "default";
87 		pinctrl-0 = <&ts_int_pin>;
89 		syna,startup-delay-ms = <10>;
91 		rmi4-f01@1 {
93 			syna,nosleep-mode = <1>;
96 		rmi4-f11@11 {
98 			touchscreen-inverted-x;
99 			syna,sensor-type = <1>;
106 	clock-frequency = <355000>;
109 		compatible = "nxp,pn544-i2c";
112 		interrupt-parent = <&tlmm>;
115 		enable-gpios = <&pm8941_gpios 23 GPIO_ACTIVE_HIGH>;
116 		firmware-gpios = <&tlmm 77 GPIO_ACTIVE_HIGH>;
125 	qcom,controlled-remotely;
130 	clock-frequency = <355000>;
137 	qcom,rset-ohms = <2100>;
138 	qcom,vset-millivolts = <3000>;
142 	gpio_keys_pin_a: gpio-keys-active-state {
146 		bias-pull-up;
147 		power-source = <PM8941_GPIO_S3>;
154 	qcom,power-source = <1>;
156 	multi-led {
160 		#address-cells = <1>;
161 		#size-cells = <0>;
183 	qcom,cs-out;
184 	qcom,current-limit = <20>;
185 	qcom,current-boost-limit = <805>;
186 	qcom,switching-freq = <1600>;
188 	qcom,num-strings = <2>;
192 	cx-supply = <&pm8841_s2>;
196 	cx-supply = <&pm8841_s2>;
197 	mss-supply = <&pm8841_s3>;
198 	mx-supply = <&pm8841_s1>;
199 	pll-supply = <&pm8941_l12>;
203 	regulators-0 {
204 		compatible = "qcom,rpm-pm8841-regulators";
207 			regulator-min-microvolt = <675000>;
208 			regulator-max-microvolt = <1050000>;
212 			regulator-min-microvolt = <500000>;
213 			regulator-max-microvolt = <1050000>;
217 			regulator-min-microvolt = <500000>;
218 			regulator-max-microvolt = <1050000>;
222 			regulator-min-microvolt = <500000>;
223 			regulator-max-microvolt = <1050000>;
227 	regulators-1 {
228 		compatible = "qcom,rpm-pm8941-regulators";
230 		vdd_l1_l3-supply = <&pm8941_s1>;
231 		vdd_l2_lvs1_2_3-supply = <&pm8941_s3>;
232 		vdd_l4_l11-supply = <&pm8941_s1>;
233 		vdd_l5_l7-supply = <&pm8941_s2>;
234 		vdd_l6_l12_l14_l15-supply = <&pm8941_s2>;
235 		vdd_l9_l10_l17_l22-supply = <&vreg_boost>;
236 		vdd_l13_l20_l23_l24-supply = <&vreg_boost>;
237 		vdd_l21-supply = <&vreg_boost>;
240 			regulator-min-microvolt = <1300000>;
241 			regulator-max-microvolt = <1300000>;
242 			regulator-always-on;
243 			regulator-boot-on;
247 			regulator-min-microvolt = <2150000>;
248 			regulator-max-microvolt = <2150000>;
249 			regulator-boot-on;
253 			regulator-min-microvolt = <1800000>;
254 			regulator-max-microvolt = <1800000>;
255 			regulator-always-on;
256 			regulator-boot-on;
260 			regulator-min-microvolt = <5000000>;
261 			regulator-max-microvolt = <5000000>;
265 			regulator-min-microvolt = <1225000>;
266 			regulator-max-microvolt = <1225000>;
267 			regulator-always-on;
268 			regulator-boot-on;
272 			regulator-min-microvolt = <1200000>;
273 			regulator-max-microvolt = <1200000>;
277 			regulator-min-microvolt = <1200000>;
278 			regulator-max-microvolt = <1200000>;
282 			regulator-min-microvolt = <1225000>;
283 			regulator-max-microvolt = <1225000>;
287 			regulator-min-microvolt = <1800000>;
288 			regulator-max-microvolt = <1800000>;
292 			regulator-min-microvolt = <1800000>;
293 			regulator-max-microvolt = <1800000>;
294 			regulator-boot-on;
298 			regulator-min-microvolt = <1800000>;
299 			regulator-max-microvolt = <1800000>;
300 			regulator-boot-on;
304 			regulator-min-microvolt = <1800000>;
305 			regulator-max-microvolt = <1800000>;
309 			regulator-min-microvolt = <1800000>;
310 			regulator-max-microvolt = <2950000>;
314 			regulator-min-microvolt = <1300000>;
315 			regulator-max-microvolt = <1350000>;
319 			regulator-min-microvolt = <1800000>;
320 			regulator-max-microvolt = <1800000>;
321 			regulator-always-on;
322 			regulator-boot-on;
326 			regulator-min-microvolt = <1800000>;
327 			regulator-max-microvolt = <2950000>;
328 			regulator-boot-on;
332 			regulator-min-microvolt = <1800000>;
333 			regulator-max-microvolt = <1800000>;
337 			regulator-min-microvolt = <2050000>;
338 			regulator-max-microvolt = <2050000>;
342 			regulator-min-microvolt = <2700000>;
343 			regulator-max-microvolt = <2700000>;
347 			regulator-min-microvolt = <2700000>;
348 			regulator-max-microvolt = <2700000>;
352 			regulator-min-microvolt = <2850000>;
353 			regulator-max-microvolt = <2850000>;
357 			regulator-min-microvolt = <3300000>;
358 			regulator-max-microvolt = <3300000>;
362 			regulator-min-microvolt = <2950000>;
363 			regulator-max-microvolt = <2950000>;
364 			regulator-system-load = <200000>;
365 			regulator-allow-set-load;
366 			regulator-boot-on;
370 			regulator-min-microvolt = <2950000>;
371 			regulator-max-microvolt = <2950000>;
372 			regulator-boot-on;
376 			regulator-min-microvolt = <3000000>;
377 			regulator-max-microvolt = <3000000>;
381 			regulator-min-microvolt = <2800000>;
382 			regulator-max-microvolt = <2800000>;
386 			regulator-min-microvolt = <3075000>;
387 			regulator-max-microvolt = <3075000>;
388 			regulator-boot-on;
398 	vmmc-supply = <&pm8941_l20>;
399 	vqmmc-supply = <&pm8941_s3>;
401 	pinctrl-names = "default", "sleep";
402 	pinctrl-0 = <&sdc1_on>;
403 	pinctrl-1 = <&sdc1_off>;
409 	vmmc-supply = <&pm8941_l21>;
410 	vqmmc-supply = <&pm8941_l13>;
412 	cd-gpios = <&tlmm 62 GPIO_ACTIVE_LOW>;
414 	pinctrl-names = "default", "sleep";
415 	pinctrl-0 = <&sdc2_on>;
416 	pinctrl-1 = <&sdc2_off>;
420 	qcom,fast-charge-safe-current = <1500000>;
421 	qcom,fast-charge-current-limit = <1500000>;
422 	qcom,dc-current-limit = <1800000>;
423 	qcom,fast-charge-safe-voltage = <4400000>;
424 	qcom,fast-charge-high-threshold-voltage = <4350000>;
425 	qcom,fast-charge-low-threshold-voltage = <3400000>;
426 	qcom,auto-recharge-threshold-voltage = <4200000>;
427 	qcom,minimum-input-voltage = <4300000>;
431 	ts_int_pin: touch-int-state {
434 		drive-strength = <2>;
435 		bias-disable;
438 	sdc1_on: sdc1-on-state {
439 		clk-pins {
441 			drive-strength = <16>;
442 			bias-disable;
445 		cmd-data-pins {
447 			drive-strength = <10>;
448 			bias-pull-up;
452 	sdc2_on: sdc-on-state {
453 		clk-pins {
455 			drive-strength = <10>;
456 			bias-disable;
459 		cmd-data-pins {
461 			drive-strength = <6>;
462 			bias-pull-up;
465 		cd-pins {
468 			drive-strength = <2>;
469 			bias-disable;
478 	phy-select = <&tcsr 0xb000 0>;
480 	vbus-supply = <&chg_otg>;
482 	hnp-disable;
483 	srp-disable;
484 	adp-disable;
490 	v1p8-supply = <&pm8941_l6>;
491 	v3p3-supply = <&pm8941_l24>;
494 	qcom,init-seq = /bits/ 8 <0x1 0x64>;