Lines Matching +full:0 +full:xd0000000
8 * internal registers to 0xf1000000 (instead of the old 0xd0000000).
9 * The 0xf1000000 is the default used by the recent, DT-capable, U-Boot
13 * registers mapped at 0xd0000000. If you have such a device you will
18 * (s/0xf1000000/0xd0000000/ in 'ranges' below).
36 memory@0 {
38 reg = <0x00000000 0x20000000>; /* 512 MB */
42 ranges = <MBUS_ID(0xf0, 0x01) 0 0xf1000000 0x100000
43 MBUS_ID(0x01, 0xe0) 0 0xfff00000 0x100000
44 MBUS_ID(0x09, 0x01) 0 0xf1100000 0x10000>;
55 pinctrl-0 = <&i2c0_pins>;
63 reg = <0x30>;
79 reg = <0x12100 0x100>;
80 clocks = <&coreclk 0>;
109 pinctrl-0 = <&fan_ctrl_low_pin &fan_ctrl_mid_pin
113 &gpio2 0 GPIO_ACTIVE_HIGH
116 gpio-fan,speed-map = < 0 0
128 pinctrl-0 = <&disk1_led_pin
140 gpios = <&gpio1 0 GPIO_ACTIVE_LOW>;
155 pinctrl-0 = <&sata1_pwr_pin>;
169 pinctrl-0 = <&sata2_pwr_pin>;
255 flash@0 {
259 reg = <0>; /* Chip select 0 */
276 partition@0 { /* u-boot */
278 reg = <0x00000000 0x000c0000>; /* 768KB */
283 reg = <0x000c0000 0x002d0000>; /* 2880KB */
288 reg = <0x00390000 0x00440000>; /* 4250KB */
293 reg = <0x007d0000 0x00010000>; /* 64KB */
298 reg = <0x007e0000 0x00010000>; /* 64KB */
303 reg = <0x007f0000 0x00010000>; /* 64KB */