Lines Matching +full:fw +full:- +full:gpios
1 // SPDX-License-Identifier: GPL-2.0-only
4 /dts-v1/;
6 #include "aspeed-g6.dtsi"
7 #include <dt-bindings/i2c/i2c.h>
8 #include <dt-bindings/gpio/aspeed-gpio.h>
12 compatible = "ampere,mtjefferson-bmc", "aspeed,ast2600";
41 stdout-path = &uart5;
49 reserved-memory {
50 #address-cells = <1>;
51 #size-cells = <1>;
57 compatible = "shared-dma-pool";
64 compatible = "shared-dma-pool";
69 no-map;
70 compatible = "shared-dma-pool";
75 voltage_mon_reg: voltage-mon-regulator {
76 compatible = "regulator-fixed";
77 regulator-name = "ltc2497_reg";
78 regulator-min-microvolt = <3300000>;
79 regulator-max-microvolt = <3300000>;
80 regulator-always-on;
84 compatible = "gpio-leds";
85 led-bmc-ready {
86 gpios = <&gpio0 ASPEED_GPIO(W, 5) (GPIO_ACTIVE_HIGH | GPIO_TRANSITORY)>;
89 led-sw-heartbeat {
90 gpios = <&gpio0 ASPEED_GPIO(N, 3) GPIO_ACTIVE_HIGH>;
93 led-identify {
94 gpios = <&gpio0 ASPEED_GPIO(S, 3) GPIO_ACTIVE_HIGH>;
97 led-fault {
98 gpios = <&gpio0 ASPEED_GPIO(P, 4) GPIO_ACTIVE_HIGH>;
102 iio-hwmon {
103 compatible = "iio-hwmon";
104 io-channels = <&adc0 0>, <&adc0 1>, <&adc0 2>,
126 ethphy0: ethernet-phy@0 {
127 compatible = "ethernet-phy-ieee802.3-c22";
135 phy-mode = "rgmii";
136 phy-handle = <ðphy0>;
138 pinctrl-names = "default";
139 pinctrl-0 = <&pinctrl_rgmii1_default>;
144 pinctrl-names = "default";
145 pinctrl-0 = <&pinctrl_rmii4_default>;
146 use-ncsi;
153 m25p,fast-read;
155 spi-max-frequency = <50000000>;
156 #include "openbmc-flash-layout-64.dtsi"
161 m25p,fast-read;
162 label = "alt-bmc";
163 spi-max-frequency = <50000000>;
164 #include "openbmc-flash-layout-64-alt.dtsi"
170 pinctrl-names = "default";
171 pinctrl-0 = <&pinctrl_spi1_default>;
175 m25p,fast-read;
177 spi-max-frequency = <20000000>;
203 bus-frequency = <1000000>;
204 multi-master;
205 mctp-controller;
208 compatible = "mctp-i2c-controller";
221 i2c-mux@70 {
223 #address-cells = <1>;
224 #size-cells = <0>;
226 i2c-mux-idle-disconnect;
229 #address-cells = <1>;
230 #size-cells = <0>;
238 temperature-sensor@48 {
242 temperature-sensor@49 {
246 temperature-sensor@4a{
250 temperature-sensor@4b {
253 #address-cells = <1>;
254 #size-cells = <0>;
276 temperature-sensor@4d {
280 temperature-sensor@4e {
284 temperature-sensor@4f {
288 temperature-sensor@28 {
292 #address-cells = <1>;
293 #size-cells = <0>;
296 sensor-type = "temperature";
297 temperature-mode = "thermistor";
303 vref-supply = <&voltage_mon_reg>;
304 #io-channel-cells = <1>;
309 #address-cells = <1>;
310 #size-cells = <0>;
316 vref-supply = <&voltage_mon_reg>;
317 #io-channel-cells = <1>;
325 i2c-mux@70 {
327 #address-cells = <1>;
328 #size-cells = <0>;
330 i2c-mux-idle-disconnect;
333 #address-cells = <1>;
334 #size-cells = <0>;
337 i2c-mux@71 {
339 #address-cells = <1>;
340 #size-cells = <0>;
342 i2c-mux-idle-disconnect;
345 #address-cells = <1>;
346 #size-cells = <0>;
350 #address-cells = <1>;
351 #size-cells = <0>;
355 #address-cells = <1>;
356 #size-cells = <0>;
360 #address-cells = <1>;
361 #size-cells = <0>;
366 i2c-mux@72 {
368 #address-cells = <1>;
369 #size-cells = <0>;
371 i2c-mux-idle-disconnect;
374 #address-cells = <1>;
375 #size-cells = <0>;
379 #address-cells = <1>;
380 #size-cells = <0>;
384 #address-cells = <1>;
385 #size-cells = <0>;
389 #address-cells = <1>;
390 #size-cells = <0>;
395 i2c-mux@74 {
397 #address-cells = <1>;
398 #size-cells = <0>;
400 i2c-mux-idle-disconnect;
403 #address-cells = <1>;
404 #size-cells = <0>;
407 ocpslot_temp: temperature-sensor@1f {
410 #address-cells = <1>;
411 #size-cells = <0>;
424 #address-cells = <1>;
425 #size-cells = <0>;
429 #address-cells = <1>;
430 #size-cells = <0>;
434 #address-cells = <1>;
435 #size-cells = <0>;
439 #address-cells = <1>;
440 #size-cells = <0>;
460 temperature-sensor@4f {
469 fan-controller@5c {
478 #address-cells = <1>;
479 #size-cells = <0>;
491 temperature-sensor@18 {
492 compatible = "jedec,jc-42.4-temp";
496 temperature-sensor@1a {
497 compatible = "jedec,jc-42.4-temp";
508 ssif-bmc@10 {
509 compatible = "ssif-bmc";
522 bmc_ast2600_cpu: temperature-sensor@48 {
530 gpio_expander1: gpio-expander@22 {
533 gpio-controller;
534 #gpio-cells = <2>;
535 gpio-line-names =
536 "presence-ocp1","presence-ocp2",
550 pinctrl-names = "default";
551 pinctrl-0 = <&pinctrl_adc0_default &pinctrl_adc1_default
561 memory-region = <&video_engine_memory>;
565 gpio-line-names =
566 /*A0-A7*/ "","","","","cpu-type-detect","i2c2-reset-n","i2c6-reset-n","i2c5-reset-n",
567 /*B0-B7*/ "","","","","host0-sysreset-n","host0-pmin-n","fru-rd-complete",
568 "chassis-id-sel",
569 /*C0-C7*/ "s0-vrd-fault-n","","bmc-debug-mode","","cpld-3v3-irq-n","","vrd-sel",
570 "spd-sel",
571 /*D0-D7*/ "presence-ps0","presence-ps1","hsc-12vmain-alt2-n","ext-high-temp-n",
573 /*E0-E7*/ "eth-phy-rst-n","eth-phy-int-n","","","","","","",
574 /*F0-F7*/ "s0-pcp-oc-warn-n","","power-chassis-control",
575 "cpu-bios-recover","s0-heartbeat","hs-scout-proc-hot","s0-vr-hot-n","",
576 /*G0-G7*/ "","","hsc-12vmain-alt1-n","","","bp-cpld-program-en","led-fp-sta-gr",
577 "led-fp-sta-amb",
578 /*H0-H7*/ "jtag-program-sel","jtag-cmpl2","wd-disable-n","power-chassis-good","","",
580 /*I0-I7*/ "","","","","","","power-button","rtc-battery-voltage-read-enable",
581 /*J0-J7*/ "","","","","","","","",
582 /*K0-K7*/ "","","","","","","","",
583 /*L0-L7*/ "","","","","reset-button","","","",
584 /*M0-M7*/ "nmi-n","s0-ddr-save","soc-spi-nor-access","presence-cpu0","s0-rtc-lock",
586 /*N0-N7*/ "hpm-fw-recovery","hpm-stby-rst-n","jtag-sel-s0","led-sw-hb",
587 "jtag-dbgr-prsnt-n","","","",
588 /*O0-O7*/ "","","","","","","","",
589 /*P0-P7*/ "ps0-ac-loss-n","ps1-ac-loss-n","","","led-fault","user-mode","jtag-srst-n",
590 "led-bmc-hb",
591 /*Q0-Q7*/ "","","","","","","","",
592 /*R0-R7*/ "","","","","","","","",
593 /*S0-S7*/ "","","identify-button","led-identify","","spi-nor-access","host0-ready","",
594 /*T0-T7*/ "","","","","","","","",
595 /*U0-U7*/ "","","","","","","","",
596 /*V0-V7*/ "s0-hightemp-n","s0-fault-alert","s0-sys-auth-failure-n",
597 "host0-reboot-ack-n","s0-fw-boot-ok","host0-shd-req-n",
598 "host0-shd-ack-n","s0-overtemp-n",
599 /*W0-W7*/ "ocp-aux-pwren","ocp-main-pwren","ocp-pgood","",
600 "bmc-ok","bmc-ready","spi0-program-sel","spi0-backup-sel",
601 /*X0-X7*/ "","","","","","","","",
602 /*Y0-Y7*/ "","","","vrd-prg-en-n","","","","host0-special-boot",
603 /*Z0-Z7*/ "","ps0-pgood","ps1-pgood","","","","","";
605 ocp-aux-pwren-hog {
606 gpio-hog;
607 gpios = <ASPEED_GPIO(W, 0) GPIO_ACTIVE_HIGH>;
608 output-high;
609 line-name = "ocp-aux-pwren";
615 gpio-line-names =
616 /*18A0-18A7*/ "","","","","","","","",
617 /*18B0-18B7*/ "","","","","s0-soc-pgood","vga-ft-press-n","emmc-rst-n","s01-uart1-sel",
618 /*18C0-18C7*/ "uart1-mode0","uart1-mode1","uart2-mode0","uart2-mode1",
620 /*18D0-18D7*/ "","","","","","","","",
621 /*18E0-18E3*/ "","","","";