Lines Matching refs:driver

15 cache and board LRAM. A CDB is a single SCSI command. The driver
17 adapter detected. The number of CDBs used by the driver can be
69 1. ADVANSYS_ASSERT - Enable driver assertions (Def: Enabled)
72    driver. If an assertion fails a message will be displayed to
75    responsible for the driver. Assertion statements may proactively
76    detect problems with the driver and facilitate fixing these
78    execution of the driver.
80 2. ADVANSYS_DEBUG - Enable driver debugging (Def: Disabled)
82    Enabling this option adds tracing functions to the driver and the
83    ability to set a driver tracing level at boot time.  This option is
84    very useful for debugging the driver, but it will add to the size
85    of the driver execution image and add overhead to the execution of
86    the driver.
92    If the driver is loaded at boot time and the LILO Driver Option
102    If the driver is built as a loadable module this variable can be
103    defined when the driver is loaded. The following insmod command
151    through /proc to the driver. The information is useful for
152    monitoring driver and device performance. It will add to the
153    size of the driver execution image and add minor overhead to
154    the execution of the driver.
176 the AdvanSys Driver to Linux' section (B.4.) above, the driver will
208 the driver, e.g.::
213 I/O Port may be added to specify the driver debug level. Refer to
220 Bob Frey <bfrey@turbolinux.com.cn> wrote the AdvanSys SCSI driver
222 and help maintain the driver.
232 AdvanSys driver in the Caldera releases.
236 driver work with a SCSI-1 disk.
239 support in the 3.1A driver.
242 suggestions to improve the driver and done a lot of testing.
255 the 3.2M driver.
270 driver development for ConnectCom (Version > 3.3F).