Documentation/networking/arcnet-hardware.rst

32 work with 100 Mbps cards, but I haven't been able to verify this myself,
50 even if it can't possibly be delivered properly (ie. because of a cable
137    must be properly terminated with 93 Ohm (or something else if you don't
140 	(Avery's note: oops, I didn't know that.  Mine (TV cable) works
146    doesn't limit the number of active hubs on the network.
299 	IRQ  7   FREE (LPT1 if you don't use the polling driver; PLIP)
329     copying buffers around.  Make SURE it doesn't conflict with any other
334 	A0000		- VGA graphics memory (ok if you don't have VGA)
340     Anything less than 0xA0000 is, well, a BAD idea since it isn't above
351     haven't already guessed, don't set this the same as any other ARCnet on
401 If you don't KNOW what kind of card you have, try looking through the
404 If your model isn't listed and/or has different settings, PLEASE PLEASE
407 Even if your ARCnet model isn't listed, but has the same jumpers as another
481   - Also, the JP- and S-numbers probably don't match your card exactly.  Try
774 MEMORY.  This means the current Linux-ARCnet driver can't use these cards.
776 the future, but don't hold your breath.  Thanks again to Juergen Seifert for
1166 	since it was already there when I got the card.  I don't know what
1169 	There is a two-jumper array for J3.  I don't know what it is for,
1218 	00000000	FF  	(Don't use this!)
1224 	11111111	0	(Don't use this!)
1240 	blinking.  I don't know what 0x3D0 is for though.  I recommend using
1272 	Memory Switch 0 (MS0) didn't seem to work properly when set to OFF
1274 	it ON first, and if it doesn't work, set it to OFF.  (It may be a
1465       haven't tested it yet.
1690        - Use JP3=IRQ14 only, if you don't have an IDE-, MFM-, or RLL-
1707     the time I tried to reach him.  Sorry Vlad, if you didn't get my reply.
1756 observe that some of those addresses are unusual and I didn't probe them; I
1758 some others that I didn't write here the card seems to conflict with the
1793 PC100, but has some additional jumpers I don't know the meaning of.
1885 Don't set this to 0 or 255; these values are reserved.
1950 J11-J15 are connecting IRQ2-7 to some pins on the UFSs. I can't
1961 This is another SMC 90C65-based ARCnet card. I couldn't identify the
2324 to be used. The first 6 switches set the address, the 7th doesn't have any
2327 card didn't work at all, it wasn't even recognized by the driver. The other
2346 [Avery's note: these don't work with my driver for some reason.  These cards
2348 software-configured and doesn't work with my driver either.  The "Waterloo
2431 manufacturer didn't put a J1 on the board. The two boards I have both
2661 8-Bit card, because there isn't any letter like "SW1" written to the
3141       . . .       |         |         + Don't use 0 or 255!