Documentation/hwmon/via686a.rst

10     Addresses scanned: ISA in PCI-space encoded address
12     Datasheet: On request through web form (http://www.via.com.tw/en/resources/download-center/)
15 	- Kyösti Mälkki <kmalkki@cc.hut.fi>,
16 	- Mark D. Studebaker <mdsxyz123@yahoo.com>
17 	- Bob Dougherty <bobd@stanford.edu>
18 	- (Some conversion-factor data were contributed by
19 	- Jonathan Teh Soon Yew <j.teh@iname.com>
20 	- and Alex van Kaam <darkside@chello.nl>.)
23 -----------------
31 			base address is not set.
36 -----------
43 For the I2C bus driver, see <file:Documentation/i2c/busses/i2c-viapro.rst>
48 Temperatures are measured in degrees Celsius. An alarm is triggered once
49 when the Overtemperature Shutdown limit is crossed; it is triggered again
52 Fan rotation speeds are reported in RPM (rotations per minute). An alarm is
56 represented, so some rounding is done. With a divider of 2, the lowest
57 representable value is around 2600 RPM.
60 An alarm is triggered if the voltage has crossed a programmable minimum
65 is read at least once. This means that the cause for the alarm may
67 hardware registers are read whenever any data is read (unless it is less
69 miss once-only alarms.
75 ------------
77 This driver handles sensors integrated in some VIA south bridges. It is
80 in which case the sensor inputs will not be wired. This is the case of
83 don't seem to make any sense, don't look any further: your chip is simply
84 not wired for hardware monitoring.