Documentation/hwmon/it87.rst

223 than the ISA access, and was only available on a small number of
244 though, so the functionality may not be available on a given system.
251 can't have both on a given board.
268 until a datasheet becomes available (hopefully.)
270 The IT8603E/IT8623E is a custom design, hardware monitoring part is similar to
280 The IT8732F supports a closed-loop mode for fan control, but this is not
287 triggered if the rotation speed has dropped below a programmable limit. When
289 a programmable divider (1, 2, 4 or 8) to give the readings more range or
290 accuracy. With a divider of 2, the lowest representable value is around
295 alarm is triggered if the voltage has crossed a programmable minimum or
298 voltage inputs can measure voltages between 0 and 4.08 volts, with a resolution
300 3.06 volts, with a resolution of 0.012 volt.  IT8732F can measure between 0 and
301 2.8 volts with a resolution of 0.0109 volt.  The battery voltage in8 does not
314 the mainboard and/or processor itself. It is a value in volts.
330 To change sensor N to a thermistor, 'echo 4 > tempN_type' where N is 1, 2,
331 or 3. To change sensor N to a thermal diode, 'echo 3 > tempN_type'.
347 it may give you a somewhat greater control range. The same frequency is
383 If a temperature sensor is configured for thermistors, the attribute values