Lines Matching refs:If
9 - reset-gpios: a GPIO spec for the reset pin. If specified, it will be
12 - power-down-gpios: a GPIO spec for the power down pin. If specified,
23 If specified, the clock will be enabled when the codec is probed,
31 If parameter is missing, mode 0 will be enabled.
40 If parameter is missing, channel 1 is chosen.
44 If present, thermal warning recovery is enabled.
47 If present, fault detect recovery is enabled.
50 If present, thermal warning adjustment is enabled.
53 If present, then fault recovery will be enabled.
63 If present, then MPCC bits are used for MPC coefficients,
67 If present, power bridge correction for THD reduction near maximum
71 If present, FFX mode runs in AM reduction mode, otherwise normal
75 If present, PWM speed mode run on odd speed mode (341.3 kHz) on all
76 channels. If not present, normal PWM spped mode (384 kHz) will be used.
79 If present, automatic invalid input detect mute is enabled.