Lines Matching refs:group

18 a group of pins, and only affects those parameters that are explicitly listed.
26 One is to set up a group of pins for a function, both mux selection and pin
27 configurations, and it's called group node in the binding document.   The other
29 different configuration than what is defined in group node.  The binding
32 On mxs, there is no hardware pin group. The pin group in this binding only
33 means a group of pins put together for particular peripheral to work in
35 group node should include all the pins needed for one function rather than
36 having these pins defined in several group nodes.  It also means each of
37 "pinctrl-*" phandle in client device node should only have one group node
39 there to adjust configurations for some pins in the group.
49   This integer with mux selection packed is used as an entity by both group
51   effects only on group node, and will get ignored by driver with config node,
56 - reg: Should be the index of the group nodes for same function.  This property
57   is required only for group nodes, and should not be present in any config
117 In this example, group node mmc0-8bit defines a group of pins for mxs SSP0
120 adjusting the configuration for pins card-detection and clock from what group