Documentation/admin-guide/spkguide.txt

31 user is using a hardware synthesizer, then Speakup will be able to
43 specific synthesizer by default, then all you need to do to use Speakup
45 assumes of course  that your synthesizer is a supported hardware
46 synthesizer, and that it is either installed in or connected to your
50 kernel with no default synthesizer.  It is even possible that your
53 your synthesizer is supported but not available, complain to the person
59 synthesizer set, or you would like to use a different synthesizer than
66 DoubleTalk LT at boot up.  You may replace the ltlk synthesizer keyword
67 with the keyword for whatever synthesizer you wish to use.  The
108 proper bootup parameter for your synthesizer, Speakup will begin
422 driver for the software synthesizer.  If you use the LiteTalk, your
423 synthesizer-specific settings would be found in /speakup/ltlk.  In other words,
506 number of the driver for the current synthesizer.
513 # Replace KWD with the keyword for your synthesizer, E.G., ltlk for LiteTalk.
516 The number five which comes back is the level at which the synthesizer
529 It is possible to change to a different synthesizer while speakup is
531 in order to use a different synthesizer.  You can simply echo the
532 synthesizer keyword to the /speakup/synth sys entry.
534 sys entry, to disable speech while one synthesizer is disconnected and
536 new synthesizer into the synth sys entry in order to start speech
537 with the newly connected synthesizer.  See the list of synthesizer
555 the synthesizer driver you wish to use.  The driver modules are all
557 synthesizer you want.  So, in order to load the driver for the DecTalk
589 of by simply echoing the synthesizer keyword into the
604 Using a software synthesizer requires that some other software be
616 software synthesizer, you must have created the /dev/softsynth device.
624 synthesizer.  To create /dev/synth, change to the /dev directory, and
633 Espeakup is a connector between Speakup and the eSpeak software synthesizer.
688 chosen software synthesizer, you still need one more piece of software
692 your software synthesizer.
694 Now you can begin using your software synthesizer.  In order to do so,
738 will accept a number from 0 through 7 for the DecTalk PC synthesizer,
974 and they could not be changed.  If you used a non-English synthesizer,
1202 Talkwith allows you to switch synthesizers on the fly.  It takes a synthesizer
1206 software synthesizer, you must also indicate which daemon you wish to
1220 synthesizer is activated.  You can use speakupconf to load your settings