admin-guide/media/imx.rst

32 camera sensors over Parallel, BT.656/1120, and MIPI CSI-2 buses.
66 - MIPI CSI-2 Receiver for camera sensors with the MIPI CSI-2 bus
84 - Supports parallel, BT.565, and MIPI CSI-2 interfaces.
115 MIPI CSI-2 OV5640 sensor, requires the i.MX6 MIPI CSI-2 receiver. But
117 therefore does not require the MIPI CSI-2 receiver, so it is missing in
140 This is the MIPI CSI-2 receiver entity. It has one sink pad to receive
141 the MIPI CSI-2 stream (usually from a MIPI CSI-2 camera sensor). It has
142 four source pads, corresponding to the four MIPI CSI-2 demuxed virtual
146 This entity actually consists of two sub-blocks. One is the MIPI CSI-2
147 core. This is a Synopsys Designware MIPI CSI-2 core. The other sub-block
167 MIPI CSI-2 virtual channels from imx6-mipi-csi2 entity. They have a
172 the four MIPI CSI-2 virtual channels (a total of five sink pads). The
174 select between a parallel sensor and any of the four MIPI CSI-2 virtual
178 IPU1-CSI0 to select between a parallel sensor and MIPI CSI-2 virtual
180 select between a parallel sensor and MIPI CSI-2 virtual channel 3 (two
187 either a video mux or from a MIPI CSI-2 virtual channel as described
413 camera interface, and the OV5640 module with a MIPI CSI-2
425 The MIPI CSI-2 OV5640 module is connected to the i.MX internal MIPI CSI-2
434 the OV5640, transmitting on MIPI CSI-2 virtual channel 1 (which is
579 i.MX6Q SabreSD with MIPI CSI-2 OV5640
583 interface OV5642 module on IPU1 CSI0, and a MIPI CSI-2 OV5640
587 OV5642 and the MIPI CSI-2 OV5640, but as of this writing only the MIPI
589 The OV5640 module connects to MIPI connector J5. The NXP part number
593 capture from the OV5640, transmitting on MIPI CSI-2 virtual channel 0:
635 from the OV5640, transmitting on MIPI CSI-2 virtual channel 0. It also