Lines Matching +full:high +full:- +full:resolution

5 		(RW) read or write TH and TL (Temperature High an Low) alarms.
7 		(typical -55 degC to 125 degC), if not values will be trimmed
11 		master level, refer to Documentation/w1/w1-generic.rst for
41 			* '-xx': xx is kernel error when reading power status
47 What:		/sys/bus/w1/devices/.../resolution
51 		(RW) get or set the device resolution (on supported devices,
52 		if not, this entry is not present). Note that the resolution
55 		values after power-on. Read or write are :
57 			* '9..14': device resolution in bit
58 			  or resolution to set in bit
59 			* '-xx': xx is kernel error when reading the resolution
62 		Some DS18B20 clones are fixed in 12-bit resolution, so the
63 		actual resolution is read back from the chip and verified. Error
82 			  conversion duration depend on the resolution (if
84 			  resolution, 750ms for 12bits.
101 			* '9..14' : set the device resolution in RAM
118 			* '-1':
144 		setting remains active until a resolution change. Then it is
146 		resolution.
177                    (insufficient power) - return a conversion error.