Lines Matching full:be

30 monitoring the systems thermal sensors. For certain error conditions it may be
32 state. After recovery, the OCC will be put back into the ACTIVE state. Anytime
40 Current Customer Settable System Power Modes that will be sent to the OCCs:
47 committee and will be used if/when approved.
57 Defaults will need to be configurable by the system owner (via JSON file)
61 The new code would be part of the openpower-occ-control repository. New code
62 will be triggered by the following:
65 - OCC Active sensor is enabled (may be covered in above bullet)
78 Default values will also be defined for Power Mode and Idle Power Saver
80 parameters, these default values will be used. If/when the customer does set any
82 will no longer be used.
84 The customer requested PowerMode and Idle Power Saver parameters will be stored
87 will be retained across power cycles, AC loss, code updates, etc.
96 New interfaces that were described in the requirements section will be
97 implemented. Parameters should be able to be set via user interface or via
100 Security impact - update of these parameters should be able to be restricted to
106 Developer impact - code to be written by OCC team with guidance from OpenBMC
111 This will be able to be tested by directly updating the power mode and idle
112 power saver setting. This testing will be automated