|
Revision tags: v6.6.25, v6.6.24, v6.6.23, v6.6.16, v6.6.15, v6.6.14, v6.6.13, v6.6.12, v6.6.11, v6.6.10, v6.6.9, v6.6.8, v6.6.7, v6.6.6, v6.6.5, v6.6.4, v6.6.3, v6.6.2, v6.5.11, v6.6.1, v6.5.10, v6.6, v6.5.9, v6.5.8, v6.5.7, v6.5.6, v6.5.5, v6.5.4, v6.5.3, v6.5.2, v6.1.51, v6.5.1, v6.1.50, v6.5, v6.1.49, v6.1.48, v6.1.46, v6.1.45, v6.1.44, v6.1.43, v6.1.42, v6.1.41, v6.1.40, v6.1.39, v6.1.38, v6.1.37, v6.1.36, v6.4, v6.1.35, v6.1.34, v6.1.33, v6.1.32, v6.1.31, v6.1.30, v6.1.29, v6.1.28, v6.1.27, v6.1.26, v6.3, v6.1.25, v6.1.24, v6.1.23, v6.1.22, v6.1.21, v6.1.20, v6.1.19, v6.1.18, v6.1.17, v6.1.16 |
|
| #
954ea91f |
| 06-Mar-2023 |
Rasmus Villemoes <linux@rasmusvillemoes.dk> |
dt-bindings: iio: ad74413r: allow setting sink current for digital input
Depending on the actual hardware wired up to a digital input channel,
it may be necessary to configure the ad74413r to sink a
dt-bindings: iio: ad74413r: allow setting sink current for digital input
Depending on the actual hardware wired up to a digital input channel,
it may be necessary to configure the ad74413r to sink a small
current. For example, in the case of a simple mechanical switch, the
charge on the external 68 nF capacitor (cf. the data sheet's Figure
34) will keep the channel as reading high even after the switch is
turned off again.
Signed-off-by: Rasmus Villemoes <linux@rasmusvillemoes.dk>
Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://lore.kernel.org/r/20230306094301.1357543-2-linux@rasmusvillemoes.dk
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
show more ...
|
|
Revision tags: v6.1.15, v6.1.14, v6.1.13, v6.2, v6.1.12, v6.1.11, v6.1.10, v6.1.9, v6.1.8, v6.1.7, v6.1.6, v6.1.5, v6.0.19, v6.0.18, v6.1.4, v6.1.3, v6.0.17, v6.1.2, v6.0.16, v6.1.1, v6.0.15, v6.0.14, v6.0.13, v6.1, v6.0.12, v6.0.11, v6.0.10, v5.15.80, v6.0.9, v5.15.79 |
|
| #
6aaf7045 |
| 15-Nov-2022 |
Rasmus Villemoes <linux@rasmusvillemoes.dk> |
dt-bindings: iio: ad74413r: add optional reset-gpios
The ad74412 and ad74413 devices have an active-low reset pin. Add a
binding allowing one to specify a gpio tied to that.
Signed-off-by: Rasmus V
dt-bindings: iio: ad74413r: add optional reset-gpios
The ad74412 and ad74413 devices have an active-low reset pin. Add a
binding allowing one to specify a gpio tied to that.
Signed-off-by: Rasmus Villemoes <linux@rasmusvillemoes.dk>
Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://lore.kernel.org/r/20221115095517.1008632-3-linux@rasmusvillemoes.dk
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
show more ...
|
|
Revision tags: v6.0.8, v5.15.78, v6.0.7, v5.15.77, v5.15.76, v6.0.6, v6.0.5, v5.15.75, v6.0.4, v6.0.3, v6.0.2, v5.15.74, v5.15.73, v6.0.1, v5.15.72 |
|
| #
1b96d663 |
| 04-Oct-2022 |
Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> |
dt-bindings: iio: addac: adi,ad74413r: improve example
Improve example by: dropping unrelated properties (status and cs-gpios)
and using generic node name.
Signed-off-by: Krzysztof Kozlowski <krzys
dt-bindings: iio: addac: adi,ad74413r: improve example
Improve example by: dropping unrelated properties (status and cs-gpios)
and using generic node name.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Acked-by: Rob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/20221004115642.63749-2-krzysztof.kozlowski@linaro.org
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
show more ...
|
| #
d26b7973 |
| 04-Oct-2022 |
Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> |
dt-bindings: iio: addac: adi,ad74413r: use spi-peripheral-props.yaml
Reference the spi-peripheral-props.yaml schema to allow using all
properties typical for SPI-connected devices, even these which
dt-bindings: iio: addac: adi,ad74413r: use spi-peripheral-props.yaml
Reference the spi-peripheral-props.yaml schema to allow using all
properties typical for SPI-connected devices, even these which device
bindings author did not tried yet.
While changing additionalProperties->unevaluatedProperties, put it in
typical place, just before example DTS.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Acked-by: Rob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/20221004115642.63749-1-krzysztof.kozlowski@linaro.org
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
show more ...
|
| #
c9adc3bd |
| 14-Oct-2022 |
Rob Herring <robh@kernel.org> |
dt-bindings: Remove "status" from schema examples, again
There's no reason to have "status" properties in examples. "okay" is the
default, and "disabled" turns off some schema checks ('required'
spe
dt-bindings: Remove "status" from schema examples, again
There's no reason to have "status" properties in examples. "okay" is the
default, and "disabled" turns off some schema checks ('required'
specifically).
A meta-schema check for this is pending, so hopefully the last time to
fix these.
Fix the indentation in intel,phy-thunderbay-emmc while we're here.
Acked-by: Nicolas Ferre <nicolas.ferre@microchip.com>
Acked-by: Thierry Reding <treding@nvidia.com>
Acked-by: Jonathan Cameron <Jonathan.Cameron@huawei.com> #for-iio
Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Acked-By: Vinod Koul <vkoul@kernel.org>
Link: https://lore.kernel.org/r/20221014205104.2822159-1-robh@kernel.org
Signed-off-by: Rob Herring <robh@kernel.org>
show more ...
|
|
Revision tags: v6.0, v5.15.71, v5.15.70, v5.15.69, v5.15.68, v5.15.67, v5.15.66, v5.15.65, v5.15.64, v5.15.63 |
|
| #
c682c963 |
| 23-Aug-2022 |
Rob Herring <robh@kernel.org> |
dt-bindings: iio: Add missing (unevaluated|additional)Properties on child nodes
In order to ensure only documented properties are present, node schemas
must have unevaluatedProperties or additionalP
dt-bindings: iio: Add missing (unevaluated|additional)Properties on child nodes
In order to ensure only documented properties are present, node schemas
must have unevaluatedProperties or additionalProperties set to false
(typically).
Signed-off-by: Rob Herring <robh@kernel.org>
Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://lore.kernel.org/r/20220823145649.3118479-2-robh@kernel.org
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
show more ...
|
|
Revision tags: v5.15.62, v5.15.61, v5.15.60, v5.15.59, v5.19, v5.15.58, v5.15.57, v5.15.56, v5.15.55, v5.15.54, v5.15.53, v5.15.52, v5.15.51, v5.15.50, v5.15.49, v5.15.48, v5.15.47, v5.15.46, v5.15.45, v5.15.44, v5.15.43, v5.15.42, v5.18, v5.15.41, v5.15.40, v5.15.39, v5.15.38, v5.15.37, v5.15.36, v5.15.35, v5.15.34, v5.15.33, v5.15.32, v5.15.31, v5.17, v5.15.30, v5.15.29, v5.15.28, v5.15.27, v5.15.26, v5.15.25, v5.15.24, v5.15.23, v5.15.22, v5.15.21, v5.15.20, v5.15.19, v5.15.18, v5.15.17, v5.4.173, v5.15.16, v5.15.15, v5.16, v5.15.10, v5.15.9, v5.15.8, v5.15.7 |
|
| #
3cf3cdea |
| 05-Dec-2021 |
Cosmin Tanislav <demonsingur@gmail.com> |
dt-bindings: iio: add AD74413R
The AD74412R and AD74413R are quad-channel, software configurable,
input/output solutions for building and process control applications.
They contain functionality fo
dt-bindings: iio: add AD74413R
The AD74412R and AD74413R are quad-channel, software configurable,
input/output solutions for building and process control applications.
They contain functionality for analog output, analog input, digital input,
resistance temperature detector, and thermocouple measurements integrated
into a single chip solution with an SPI interface.
The devices feature a 16-bit ADC and four configurable 13-bit DACs to
provide four configurable input/output channels and a suite of diagnostic
functions.
The AD74413R differentiates itself from the AD74412R by being
HART-compatible.
Signed-off-by: Cosmin Tanislav <cosmin.tanislav@analog.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/20211205114045.173612-3-cosmin.tanislav@analog.com
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
show more ...
|